Replacement Bulb for Wesbar Low Profile Trailer Tail Lights 403026 and 403076

Question

Question:

Looking for an old part , need driver and passenger side! Part number 403026 driver 403076 passenger Wesbar replacement bulbs sealed

asked by: Kenny

0

Expert Reply:

It sounds like you're looking for the replacement bulbs only for the Wesbar Low Profile Trailer Tail Lights # 403076 and # 403026. The replacement bulbs for these lights are the Replacement Light Bulb 1157
# A1157B. Since those lights are submersible and will have a seal on the inside of them, you'll want to be careful when removing and re-installing the lens cover when replacing the bulb to make sure there is no damage done in the process.

expert reply by: Erik B

0

Answer 1

The older generations of the Wesbar submersible low-profile lights came with sealed light bulb capsules that are not replaceable. If your capsule is sealed, then your best option is to replace the lights with new lights like part #403026 and #403076.…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 4

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 5

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 6

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 7

Hello John, thanks for reaching out. Yes, the mounting holes on the TecNiq Contoured Seven Function Box Style Tail Light #TN42XR (driver side) and #TN62XR (passenger side) are exactly the same as the Wesbar 271595 tail light. They are 2" apart…

view full answer...

Replacement Bulb for Wesbar Low Profile Trailer Tail Lights 403026 and 403076

Products Featured in This Question

Continue Researching