Replacement Controller for Rieco Titan 300898 Leveling System

Question

Question:

I have an older system four point that used a control module number 300898 no hall monitor sensors that looks just like this controller. My question is whether this controller will replace my controller? I went to Reich-Titan and Lippert Components and they have no idea what I should use. Both said to contact the other.

asked by: Eric H

1

Helpful Expert Reply:

Thanks for the picture! That's definitely the same controller as our part # LC242623 so this would be exactly what you'd want.

expert reply by: Jameson C

1

click to enlarge

Answer 1

It sounds like you have a wiring issue with your Lippert Ground Control system. Since all your jacks are showing as error you will want to start by checking the wiring going into the main Control Module #LC242623 located inside your Camper. This is…

view full answer...

Answer 2

Since you have the Lippert Ground Control 2.0 with the module number 307296 the correct controller is the part #LC242623 that you referenced.

view full answer...

Answer 3

The Replacement 4-Point Controller for Lippert Components Ground Control 2.0 Electric Leveling System #LC242623 is not the same as the Replacement Control Module for Lippert Ground Control 3.0 Electric Leveling System #LC304136. Although they look…

view full answer...

Answer 4

The replacement control panel part #LC421484 is the correct control panel for the Lippert Hydraulic Level Up system you most likely have. If you were looking for something different or if you have a different system let me know.

view full answer...

Answer 5

I sent all of this to my tech contact at LCI to see what they this is the problem and they were able to come up with a way to use the voltage readings to determine where the issue is: There are 4 wires on the harness as follows Black= power (need to…

view full answer...

Answer 6

I looked up the Dometic 12 Volt RV Refrigerator RM 1272 and found it measures 59-31/32" tall x 37-1/2" wide x 26-11/16" deep. The best replacement for this is the Everchill RV Refrigerator with Freezer part #324-000119 which measures…

view full answer...

Answer 7

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 11

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 12

Hey Doug! The Firestone Ride-Rite Air Helper Springs #F35FV are the right kit for your 2026 Ford F-350 FX4 dually. However, you will need to measure to be sure it fits. The distance from the top of your rear axle to the top of the jounce bump stop…

view full answer...

Replacement Controller for Rieco Titan 300898 Leveling System

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching