Truxedo Lopro Shur Bond Replacement Velcro

Question

Question:

Does the Velcro strip have the elongated slot cut in it for the pins that came with the original ? Does it need to be used with replacement ?

asked by: Larry V

0

Expert Reply:

Yes the Replacement TruXedo Shur-Bond Velcro Brand Fastener for 6-1/2' Beds -1-5/16" Wide part # TX1115174 that you have looked at does have the elongated slots. When replacing it you will utilize these to get the strips in place and get your cover back snug and secure.

I've linked a video below where you can see these.

expert reply by: Randy B

0

Answer 1

The Replacement Adhesive Velcro Strip #A20790 is 16' long x 1-1/4" wide, and I believe that's what you were referring to by hook portion, and yes it is correct. We do not carry Lund tonneau covers or their replacement parts so while I…

view full answer...

Answer 2

I have a solution for you, and the strips that you're referring to are going to come in a couple different sizes, but none of them are going to be 1-1/16" wide. The #TX1117876 strips you're referring to are 1" wide, which have the…

view full answer...

Answer 3

The Replacement Velcro Strip for Access Tonneau Covers - 1-1/2" x 17' #A30474 is made for Access tonneau covers, but that it is not to say that it cannot be used on your Lund Rollup L96092. We do not carry any Lund tonneau covers or parts. I…

view full answer...

Answer 4

Hey Jack! You can use the Kodiak Disc Brakes #KOD67FR as a replacement as long as you have a #84 spindle on that trailer. These use #L68149 inner and #L44649 outer bearings so you need to make sure that matches what you have now. If you aren't…

view full answer...

Answer 5

Hey Bryan, I would go with the Kenda Karrier KR53 part #KE72EV to use as a spare on your 2012 Jayco Jay Flight travel trailer. Its the correct size wheel and tire that you need, it's the Load Range D you need, and also is the best priced option…

view full answer...

Answer 6

We have replacement tonneau cover Velcro that is exactly 1-5/16 inches wide with the Truxedo part #TX1115174 which would fit your rails. It can be cut down shorter too as it is 80 inches long.

view full answer...

Answer 7

There is one rivet on each side rail that holds the existing Velcro strips in place. In order to replace these Velcro strips you need to drill out each rivet, pull the strips out from the channels, slide the new strips (Replacement TruXedo Shur-Bond…

view full answer...

Answer 8

It looks like you're already in great shape because you have the three major components needed for flat towing: the etrailer Invisible Base Plate Kit part #e98948, the Blue Ox Patriot Portable Flat Tow Brake System part #BLU37TR, and the Blue Ox…

view full answer...

Answer 9

Hi Johnny! The 1-5/16" Replacement TruXedo Shur-Bond Fastener #TX1115174 is the one you need. The 1-5/16" measurement is the overall width of the plastic backing that slides into the rail, rather than just the hook-and-loop portion…

view full answer...

Answer 10

Hi Ben, that’s a great question, and you’re right to think about it ahead of time because aluminum trailers can flex more than steel, especially when you hang weight off the side like a spare tire. The Brophy part #SPTC will work on an aluminum…

view full answer...

Truxedo Lopro Shur Bond Replacement Velcro

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching