Replacement Drive Head for Solera Hybrid RV Awning

Question

Question:

I have a solera hybrid awning and I need to replace the manual head Can I use this version?

asked by: Maurin J

0

Expert Reply:

The correct replacement drive head for the Solera Hybrid RV Awning is the Solera Manual Crank Style Awning Drive Head part # LC300031 for black or part # LC300029 for white.

expert reply by: Conner L

0

Answer 1

There is no difference. The Solera Manual Crank Style Awning Drive Head #LC300031 in black and the #LC300029 in white are the exact same thing except for the color. These replacement drive heads are for the Solera short, pitched and flat awning…

view full answer...

Answer 2

I was not able to find a reference to your exact part number but the correct replacement drive head for the Solera Hybrid RV Awning is the Solera Manual Crank Style Awning Drive Head part #LC300031 for black or part #LC300029 for white.

view full answer...

Answer 3

Hi Robert; do the buttons still work or is it no longer functional? You can typically still use the control panel, sometimes you can even reattach the buttons, it just won't look as pretty. The only compatible replacement is the same Replacement…

view full answer...

Answer 4

The Electric Stabilizer Jack Support Arm #LC1134122 and Foot Assembly #LC157584 are the only replaceable parts for the legs on your Lippert PSX1 Stabilizer Assembly #LC298707. If you bent the leg itself you will need to replace the entire assembly.

view full answer...

Answer 5

To remove the old pin you'll need to remove the cover, remove the two retaining pins, and then slide the old pin out. To install the #LC93FR you'd just reverse the process.

view full answer...

Answer 6

Sounds like the driver head of your manual Solera awning is in need of replacing. For that we have the part #LC300031 which will replace what you have and allow you to roll yours up.

view full answer...

Answer 7

The gearbox inside of the Solera Manual Crank Style Awning Drive Head part #LC300031 is not available separately as a replacement part therefore if you need to replace this you will have choice but to replace the entire assembly.

view full answer...

Answer 8

The gears alone cannot be replaced; you would need to replace the entire thing with the Drive Head for Solera Manual Crank-Style Awning #LC300031.

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 12

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Replacement Drive Head for Solera Hybrid RV Awning

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching