Replacement Magnets for Dexter 12-1/4 x 4 Electric Trailer Brake Assemblies

Question

Question:

looking for magnets for dexter 7 bolt cast electric brake 12.25x4 for a 1990 tag along trailer

asked by: Steve H

0

Expert Reply:

For a 12-1/4 x 4 Dexter cast brake assembly you would need replacement magnet # BP01-301. It comes with one magnet and a spring.

expert reply by: Michael H

0

Answer 1

Hi Frank, While we can get you a brake controller for your 2020 Chevy Colorado, there isn't a plug-in option and harness because the truck doesn't have a plug under the dash. That said, the wires are already run to the cab, so it isn't…

view full answer...

Answer 2

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

The appropriate torque spec for any application will vary depending on the construction of the wheel as well as on the stud size. I suggest checking the wheels you're using to see if their manufacturer has a suggested torque rating. Steel trailer…

view full answer...

Answer 5

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

Hey John, the replacement gear kit you'd need is the part #TJD-12000-RODNUT which I attached two pictures that have instructions and an install diagram.

view full answer...

Answer 8

We sure do Jerry and welcome back! To replace the Replacement Dexter Versa-Flex Torsion Arm Kit item #DX24FT. This replacement arm is designed for a 3,700-lb Dexter Versa-Flex axle. It's going to replace the entire arm assembly and rotor hub. It…

view full answer...

Replacement Magnets for Dexter 12-1/4 x 4 Electric Trailer Brake Assemblies

Product Page this Question was Asked From

Continue Researching