Which Sumo Springs Do I Need For 2003 Chevy Suburban 1500 2WD

Question

Question:

Which sumo springs will fit my 2003 Chevy suburban 1500 2wd

asked by: Eddie

0

Expert Reply:

The SumoSprings Solo Custom Helper Springs you need for the 2003 Chevy Suburban 1500 2WD are part # SSR-204-40. The SumoSprings replace the bump stop on the Chevy to help with rear sag and suspension support. They are a progressive spring made from microcellular material that is designed to compress lightly with lighter loads and up to 80% with heavy loads. The progressive load control does not compromise the ride quality like with the dense rubber springs that are always fully engaged.

expert reply by: Heather A

0

click to enlarge

Answer 1

If your leveler shocks didn't change anything around your rear bump stops, I recommend the SumoSprings Solo Custom Helper Springs item #SSR-204-40. These replace your bump stops and limit the travel of your suspension while cushioning your ride.…

view full answer...

Answer 2

Hi Arman, The Timbren Rear Suspension Enhancement System #TGMRYS4 are rated for 6,000lbs so they'll definitely help with the sagging, but being as high capacity as they are they'll likely also affect your unloaded ride quality in a negative…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

Hey Doug! The Firestone Ride-Rite Air Helper Springs #F35FV are the right kit for your 2026 Ford F-350 FX4 dually. However, you will need to measure to be sure it fits. The distance from the top of your rear axle to the top of the jounce bump stop…

view full answer...

Answer 5

Since the pin weight of your camper is 2.1k, I recommend going with the LoadLifter 5000 opposed to the 7500. While technically there is not reason you couldn't use the 7500 kit, it really is not necessary for a camper like yours. Generally the…

view full answer...

Answer 6

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 7

I do have a solution, but we do not have either of the Draw-Tite hitches. Instead, I recommend the Curt Trailer Hitch Receiver #C15324 for your 2004 Suburban. This is also a Class V hitch. It has an even higher capacity when compared to Draw-Tite…

view full answer...

Answer 8

The 7 inch Dexter Brake Assemblies like the part #23-48 do use clips to attach the magnets to the assemblies. I went and pulled one from our warehouse and found that in order to attach the magnet to the arm you would need to slide the magnet over the…

view full answer...

Answer 9

The #BP19-001 retaining clips are designed to fit the Dexter 7-inch brake magnets. Our contact at Dexter said the BP19-001 will work on both the 7-inch round and the 10-inch oval magnets. The replacement magnet clip, part #BP19005 will fit 10, 12,…

view full answer...

Which Sumo Springs Do I Need For 2003 Chevy Suburban 1500 2WD

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching