Solution for Damaged 66302 Leveleg Jack on RV

Question

Question:

I have a 66302 Levelegs 13” 7.5k leveling system and Have a bent rear right leg. I would like to know if this could be a replacement since mine is discontinued. 2007 KZ Escalade 36ksb.

asked by: Malik C

0

Expert Reply:

Only solution would be an all new system like the Lippert Ground Control 3.0 part # LC358590 since your stabilizer/leveler system has been discontinued and we don't have any replacement parts for it.

expert reply by: Jameson C

0

Answer 1

I recommend the Bauer Products European Style RV Entry Door Lock #BA38AR to replace your Bargman L400. Since there is not a direct bolt on replacement for the Bargman L400 you will need to fabricate a panel to cover the larger hole on your door and…

view full answer...

Answer 2

Hey Les, thanks for reaching out. So, the 18,000 BTU Furrion Chill Cube AC Unit #LC94DX can replace your Coleman Mach AC unit, but you will need to replace your controller, distribution box and thermostat as well. According to Furrion, the Chill Cube…

view full answer...

Answer 3

The only solution I have is for a complete replacement system. Unfortunately, the Atwood Leveleg system was discontinued so there is not a replacement jack available. For a replacement, I recommend the Lippert Ground Control 3.0 Electric 5th Wheel RV…

view full answer...

Answer 4

Yes, but the replacement motor we currently carry for your Atwood landing gear is part #LG-142178.

view full answer...

Answer 5

Atwood was sold to Dometic a few years back and replacement parts for older landing gear are scarce. We do still have Stromberg Carlson Landing Gear repair kit for the follow jack that will fit, part #LG-146060. For a lead jack repair kit use…

view full answer...

Answer 6

Hey Jairo. So we do not offer a direct replacement for the Norcold N611, but we do have a good replacement option for you. It really comes down to what will fit in your cutout space. Take a look at the Norcold RV Refrigerator w/ Freezer - 8.2 cu ft -…

view full answer...

Answer 7

A direct replacement for your Winntec Model 6020 is the Automatic Changeover RV LP Gas Regulator #37207-30395 as the BTU rating is compatible and they have the same fitting sizes.

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 12

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Solution for Damaged 66302 Leveleg Jack on RV

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching