Video Transcript for Review of B and B Molders RV Water Inlets - City Fill Inlet - BM42GR

Hello everybody, this is Jeff at etrailer.com. Today we're gonna take a look at this B&B Molders vented RV docking station with the city tank fill switch. Now, this isn't just a bunch of loose inlets that are being scattered around your RV, this docking station's gonna keep all your essential hookups in one nice recessed panel that's built right into your RV's wall. If you notice the door on this has a key locked door that it can be locked to help protect everything when it's not in use. And then you can just put your key in to unlock it and open the door up. Another nice feature it has, if you notice right up here, these built in gates that you can just swing to the sides has two of them.

So if you need to hook up any hoses, let's say over here, when you swing the door down, you can still have your hose hooked up without closing the door and locking it if you prefer. Since there isn't even no connections over here, you could just flip this one back in this place and then just use the one side. And if you don't have any connections, you just put these back in there and they'll give you a whole complete door that you can lock. Now, this will mean that your setup's gonna stay clean. Your connections are gonna stay protected all while keeping the outside of the RV nice, neat and clean.

Now also, whether you're hooked up at a campsite or preparing for off-grid travel, you can switch between using your city water and then filling your RV's fresh water tank just by flipping a switch. Right here you can notice there's a blue handle switch here, the position it's in right now, and actually, you can actually look at the lid at the top here, and it tells you what all these are down in here on the lid. So right now, it's showing you in this position, parallel across, it's for tank fill. If you flip the switch down perpendicular like that, you can see that's for your city water. So just by flipping it back and forth, you can control where you want it.

There's no crawling around having to reroute your hoses. All you have to do is just hook up once and choose the mode that fits your day, makes it very quick and simple. Makes your camp set up easy every time. Now also, if you notice right down here next to the connection here, you can see they do have a vent in there for your fresh water tank. Now, both water inlets on the back here, they are equipped with check valves that'll prevent water from back flowing into your hose.

It's one of those details that you don't always see, but it does make a difference in keeping your water supply clean and your set up worry-free. The water lines themselves are half inch MPT connections. Now also, basically when it's time to clean your blackwater tank, you shouldn't have to mess with any shared connection. This docking station's gonna give you a dedicated inlet right here just for flushing the tank. Hook your hose up there, tighten it on there, you just hook up a separate hose, flush it out thoroughly, and then move on without worrying about any cross contamination or mess. You notice, it does include the sealant tape when you install it and the hardware for installation. A few overall dimensions on this, the overall width, this side to this side is 13 inches wide, height, top to bottom, seven and three quarter inches tall. The depth, three and three quarter inches deep. Now the cutout dimension, which is the part that's gonna fit into your RV, needs to be 11 and one sixteenth inches wide, and about six inches tall. But again, you can see, turn it to open it. If you need to lock it, just turn it, move your key, and then the door's locked, nobody can get into it. But that's gonna do it for a look at the B&B Molders vented RV docking station with the city tank fill switch.