Transom Strap Recommendation for Length Needed of 2 foot 3 inches

Question

Question:

I need a length of 2foot 3inch from boat to trailer hook up points. I know this item is advertised as 2foot length, but would it work over a 23inch length? Regards

asked by: Gerald F

0

Expert Reply:

Since the length you need is 2 foot, 3 inches the correct length of BoatBuckle Transom strap you'd need is the part # IMF14207 which can stretch out to up to 4 feet in length. It would easily tighten down to the length you need as well.

expert reply by: Jameson C

0

Answer 1

Hey Gary! The BoatBuckle Heavy Duty Ratchet Transom Tie-Down Straps #IMF14206 will work out great for your setup. The 2' strap is actually just the "loose" end and it doesn't include the strap side that's connected to the…

view full answer...

Answer 2

Good to hear from you again, Gary! Yes, the MORryde Locking RV Storage Box #MR43RR is what you're looking for. This enables you to utilize that cavity for storage space, and it fits 26-3/4" to 28" opening widths. Does this look like it…

view full answer...

Answer 3

I have a solution for you, however, I actually measured one of these for you and I found that at its shortest, the BoatBuckle Heavy Duty Ratchet Transom Tie-Down Straps #IMF14206 would be around 18 inches long, which is a bit too long for what you…

view full answer...

Answer 4

I recommend using the BoatBuckle Heavy Duty Ratchet Transom Tie-Down Straps in either a 2' #IMF14206 4' #IMF14207 or 6' #IMF14208. You will want to find the appropriate length depending on your boat and trailer. These straps are all rated…

view full answer...

Answer 5

The minimum length you'll get out of the BoatBuckle Heavy Duty Ratchet Transom Tie-Down Straps #IMF14206 is about 17" and that's inside hook to inside hook.

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 11

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 12

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Transom Strap Recommendation for Length Needed of 2 foot 3 inches

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching