Will Bearing Buddies Prevent Water from Getting into Hub
Updated 05/16/2019 | Published 05/15/2019
Question:
My boat trailer has a thread hub with a 2.243 inside diameter, but will the threaded area allow water to pass once I have inserted the Bearing Buddy? The Vortex plastic protector screw in with an o-ring has cracked and Id like to replace with a Bearing Buddy, Thanks,
asked by: Barry B
Expert Reply:
Bearing Buddies like # BB2240 are waterproof. They are commonly used in boat applications so you would not have to worry about them allowing water past them into your hub. Based on the dimensions of your hub these are the correct fit.
I attached a review video for this kit for more info for you to check out as well.
Product Page this Question was Asked From
Bearing Buddy Bearing Protectors - Model 2240 - Chrome Plated (Pair)
- Trailer Bearings Races Seals Caps
- Caps
- Bearing Protector Grease Cap
- 2.24 Inch
- 5200 lbs Axle
- Bearing Buddy
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Video: All About the Grease Seal
- Shop: DeeMaxx Stainless Steel Drive-In Grease Cap w/ Plug - 1.98" Outer Diameter
- Search Results: bearing buddies
- Shop: Bearing Buddy Bearing Protectors - Model 2328SS - Stainless Steel (Pair)
- Shop: Dexter 9-3/4" Hub-and-Rotor Assembly - 5 on 4-1/2 - Zinc - 4,200 lbs
- Q&A: Does The Bearing Buddy Protect the Bearing from Water
- Shop: Dexter Boat Trailer Axle - 89" Long - Galvanized
- Shop: Bearing Buddy Bearing Protectors - Model 2328A w/ Auto Check - Chrome Plated (Pair)
- Search Results: spindle wear sleeve
- Search Results: oil bath caps
- Search Results: 2328 grease seal
- Search Results: 010 168 00
- Search Results: disc brake kits
- Shop: Bearing Buddy Bearing Protectors - Model 2328A-SS w/ Auto Check - Stainless Steel (Pair)
- Shop: Bearing Buddy Bearing Protectors - Model 2047A w/ Auto Check - Chrome Plated (Pair)
- Q&A: Does Install of Grease Seal in Hub Require Greasing Hub Bore
- Q&A: Trailer Hub Grease Seals Need to be Greased before Install
- Search Results: dexter vault hubs
- Q&A: Where Does O-Ring of Dexter Vault Kit # DX52UR Go
- Q&A: Is there an Interchangeable Hub for Mine that Had DB-42 Stamped on it? 3,500 Pound Axle.
- Q&A: Best Solvent to Clean Old Grease Off Bearings
- Q&A: How Do You Know When Trailer Brake Pads/Drums Need to Be Replaced