Brake Controller Wiring Adapter Location on 2017 Ford F-150

Question

Question:

where do you plug the jumper harness into under dash on 2017 F150xlt..picture would be helpful

asked by: Bo B

0

Expert Reply:

If you take a look at the accompanying photo you can see exactly where the location is on a 2017 Ford F-150 to plug in the Plug-In Wiring Adapter for Electric Brake Controllers # 22292; additionally I have added a link to a video which shows not only where the location is, but how to find the plug-in port. The plug will be on the right-hand side behind the console.

Adapter # 22292 is the correct one for a '17 F-150 and works with the following brake controllers:

- Prodigy P3 Trailer Brake Controller # 90195
- Prodigy P2 Trailer Brake Controller # 90885
- Primus IQ Trailer Brake Controller # TK90160
- Voyager Trailer Brake Controller # 39510
- PowerTrac Brake Controller # 39523
- Brake EVN Brake Controller # TK63VR

expert reply by: Kyle S

0

click to enlarge

Answer 1

We can get you everything you need for towing with your 2017 Toyota Sienna XLE. By plastic shield, I believe you are referring to the appearance panel underneath the Sienna, and that will have to trimmed a bit in each of the hitches available for the…

view full answer...

Answer 2

You're right, the mounting bracket is unique (in a good way) for the Curt TriFlex NEXT Trailer Brake Controller #C24VV. The bracket is smaller and all you do is put the included adhesive tape on the bracket and stick it wherever you like under…

view full answer...

Answer 3

If your Curt TriFlex Trailer Brake Controller #C24VV is just showing R then most likely you will need to recalibrate the controller. To do this, you can unplug and then plug back in the connector on your trailer. You will know it's recalibrated…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

To install a Redarc Tow Pro Liberty in your 2023 Toyota Tacoma Sport you will need the following parts: Redarc Tow-Pro Liberty Brake Controller item #RED24FR Plug-and-Play Wiring Harness for Redarc Tow-Pro Trailer Brake Controllers item #RED99FR…

view full answer...

Answer 8

The Dometic RV Water Heater - Gas - Automatic Pilot - 12 Volt - 8,800 Btu - 6 Gal Tank Item AT96121 is the direct replacement for the GC6AA-10E. Unfortunately it is out of stock with no expected restock date. Instead I recommend the Furrion RV…

view full answer...

Answer 9

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 10

Since wire color codes are NOT universal, we always recommend wiring by function, rather than wire color. If you look at the Trailer Wiring FAQ article I have linked you to, you can see some diagrams showing the proper way to wire a vehicle and…

view full answer...

Answer 11

Hey Walter! We do indeed have these Redarc parts for your 2024 Ridgeline. What you'll need is the Redarc Tow-Pro Liberty #RED74CR, which is simply our own part number that kits together both the EBRH-ACCNA Liberty Controller and the TPH-013…

view full answer...

Answer 12

Hey Bob. There's two possible locations for the brake controller port on your 2026 Ford F-150. The most likely one is on your dash behind the coin holder above the 4WD knob. It'll be connected to the back of the coin tray which is only…

view full answer...

Brake Controller Wiring Adapter Location on 2017 Ford F-150

Featured Help Information

Miscellaneous Media

Continue Researching