Are the Fuse Taps Required To Install the Air Lift WirelessAIR Compressor System Part # AL74000

Updated 05/07/2019 | Published 05/06/2019

Question:

Do I have to use the fuse adapter with the compressor wiring? I plugged into an used fuse prong that that is hot only when the ignition is on. Is this acceptable?

asked by: Jim S

Expert Reply:

The fuse adapter that is included with the Air Lift WirelessAIR Compressor System part # AL74000 is optional therefore, it does not have to be used. However, you will need to run the power wire from the compressor relay directly to an un-fused side of the ignition. If this is what you are tied into now then you are good to go. The complete instructions for the above kit are attached for you as well.

expert reply by: Conner L