Is There Typical Way to Remove Hub That is Stuck

Question

Question:

Snow bear - how do I get off the wheel hub...ive removed outer bolt, removed outer bearing. Can.t get wheel hub off to access inner bearing

asked by: Gary H

0

Expert Reply:

There really isn't a tried and true method to get your hub off, particularly if yours somehow got hot enough that it basically welded itself to your spindle. The only thing I can really recommend is using a hammer and trying to hammer it out as best you can. Essentially, brute force.

expert reply by: Kyle S

0

Answer 1

For the Dexter 10K axles a 5/8" wheel nut #95188.

view full answer...

Answer 2

The three most common lug stud sizes for a trailer are 1/2"-20, 9/16"-18, and 5/8"-18. In order to make sure you get the correct lug nuts you need to measure the lug studs on the trailer now as we have no way to look this up for…

view full answer...

Answer 3

Hi Conrad! That doesn't sound good, hopefully it didn't cause you too much of a problem when those bolts failed. I would be happy to help you find some upgraded parts. However, we don't have a way of knowing what is on a particular…

view full answer...

Answer 4

The best way to determine the height needed is to measure from the top of your trailer frame to the top of the sides of your boat. If the 40" Tall Guide-Ons #CE27626 sit right at or slightly above the sides of your boat then the shorter will…

view full answer...

Answer 5

The recommended brackets to use with the Fulton fenders part #F008551 is the #CE26061G-2. I attached a picture that shows how a customer used these brackets with this fender for you to check out as well.

view full answer...

Answer 6

Thanks for the photo. Honestly 5 inches of clearance from the fender to the top of the tire is fine if that is what you desire. We normally recommend 4 inches to allow for the suspension travel whether with leaf springs or torsion axles to allow…

view full answer...

Answer 7

As of right now, there are no backup camera kits, like the: -Furrion Vision S Wireless RV Backup Camera System w/ Night Vision #FOS43TASF that are going to be compatible with your trucks OEM monitor. All of these systems will need to use their…

view full answer...

Answer 8

Unfortunately William, I have no way to look at exactly what parts are installed on your Karavan KHD-2000-60-8-RR utility trailer. Based on images I could find it does look like the Incandescent Tail Light #ST56RS you found. If you can take some…

view full answer...

Answer 9

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 10

While we do not have the exact Lippert hub/drum we do have the Dexter #K08-201-98 equivalent. This hub has the same 6 on 5-1/2" bolt pattern and fits the same size spindle. The hub includes all new bearings, races, spindle nut, retainer, grease…

view full answer...

Answer 11

The first thing to try to is add some penetrating oil like WD40 and let it sit for awhile. You can then try tapping the bearing to try and remove it. You don't want to hit it too hard because you can damage the spindle. It is possible that the…

view full answer...

Is There Typical Way to Remove Hub That is Stuck

Continue Researching