Hey James, you can go with a 4k axle leaf spring like the part #e22YR in place of what you have now while it has a slightly higher weight capacity it's not enough that it would create a harsh ride quality. This is a 26 inch long spring though so…
The magnet should only make contact with the inside of the brake drum when power is applied to the magnet. If it is making contact with the drum all the time, you may have residual power running on the brake wire that is just enough to cause the…
Hey Eric, I checked with the manufacturer, TST, and the battery is not replaceable on the Internal Tire Sensor for TST TPMS Systems #TST-507-INT-S1. That said, the battery on these lasts four years so it'll be some time before you'll need to…
The most popular trailer wheel bolt pattern is the 5 on 4-1/2 inch bolt pattern and as far as we are aware the bolt pattern you mentioned is not used on trailers at all. So my bet is you probably have the 5 on 4-1/2 inch. I attached a help article…
Your Kaufman Trailer with the 7,000lb Lippert axles will use a Bearing Kit #BK3-200 to rebuild the axles. This will be all you need if the brakes and hubs are still in good condition. If the brakes are worn you can replace them with the Dexter…
Hey Phillip, since we know you have 3,500 lb axles we can help but it's not based on the VIN. Since we don't know what brake assembly brand you have on your trailer but we do know capacity the correct replacement assemblies are the part…
Hi Ross; the #SP-179275 and #e69SR are identical. The only real difference between the two slipper springs is going to be the cost. Since there will be no difference in performance in salt water I would say get whichever one is cheaper.
The correct replacement bearing kit for a 6,000 lb Dexter axle is the following: - Bearing Kit #BK3-100 This comes with the correct replacement bearings, races, and seal for one hub, so you'd need a quantity of two bearing kits for one axle.
The best option we have for your 7' x 12' V-Nose trailer is the Adco SFS AquaShed Trailer Cover item #290-46002. This cover is 12' long x 8' 10" wide x 7' 10" tall. This cover has integrated straps and ropes to prevent…
To replace your NOK AD2527E seal you can use #168233. It has an inner diameter of 1.688 inches and an outer diameter of 2.332 inches. Based on what I could find on the NOK AD2527E the inner diameter is the same and the outer diameter is 2.328 inches.…
Your trailer must have free backing brakes if you have never used the surge brake actuating coupler reverse lockout. If you did not have free backing brakes, your brakes would most likely brake even if they didn't lock up when you back up because…
Filter Results
