Brake Controller Connector Location on a 2007 Ford F-550
Updated 04/19/2019 | Published 04/18/2019 >
Products Featured in This Question
Question:
I cant find the wires in the dash for my replacement trailer controller in 2007 F550.
asked by: Sarah
Expert Reply:
The brake controller adapter, like part # 3065-P for a Tekonsha brake controller like the P2 # 90885, installs at the connector which is located behind the storage pocket that is built into your center dash right above the ashtray (see attached photos).
I have attached the installation details for this adapter which will apply to matter what brand brake controller you have. Please note that in some cases you may need to run additional wiring # 37185 to complete the brake controller circuit. If you happen to not have the connector for the brake controller then you will need to install the Universal Wiring Kit # ETBC7. Attached is a sample installation video of this kit being installed on a 2006 Ford F-650 you can reference if it comes to it.
Product Page this Question was Asked From
Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers - Ford
- Accessories and Parts
- Trailer Brake Controller
- Wiring Adapter
- Plugs into Brake Controller
- Vehicle Specific
- Tekonsha
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Lippert Replacement 500:1 Motor for Electric In-Wall RV Slide-Out System - High Torque
- Shop: Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers - Ford
- Shop: Brake Controller
- Article: Brake Controller Installation on a Ford Super Duty Truck (2005-2007)
- Video: An In-Depth Look at the Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers
- Shop: Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers
- Shop: Tekonsha Prodigy P2 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Shop: Adapter 4-Pole to 7-Pole and 4-Pole
- Shop: Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers - Ford
- Video: Ultimate Overview of the A-Frame Trailer Jack
- Search Results: inner jack tube
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Shop: Buyers Products Hitch Plate with 2" Receiver Tube - Ford
- Q&A: How is the Brake Buddy Powered if Battery is Disconnected?
- Q&A: Will the Brake Buddy Battery Maintainer work with Battery Disconnect RM-766
- Q&A: Adding a Brake Controller and 7-Way Connector to a 2006 Lexus RX 330
- Shop: Trailer Hitch
- Q&A: Can the Prodigy RF Brake Controller Use 12 Volt Power from a Trailer Mounted Battery
- Search Results: proportional controller trailer brake controller
- Video: Review of Reese 5th Wheel Hitch Rails - Custom fit - RP57KR
- Video: Ultimate Overview of the Curt Spectrum Brake Controller w/ Custom Harness
- Video: Bright Way Push-to-Test Trailer Breakaway Kit Review and Installation 3802308
- Search Results: brake controller
- Search Results: trailer brake controller
- Search Results: utility trailer side rails
- Search Results: electric brake breakaway system
- Search Results: 90195
- Q&A: Troubleshooting Curt TriFlex Trailer Brake Controller C24VV That Displays U Error Code
- Q&A: How to Reset Curt Triflex Brake Controller that Brakes That Brakes too Long and Has Random Message
- Q&A: Curt Brake Controller Wiring Harness for 2007 Ford F-350



