Mounting Pad Dimensions of K-Source Backup Mirror # KSC088

Question

Question:

Hi there, What are the dimensions of the mounting pad?

asked by: Tyler B

1

Helpful Expert Reply:

I attached a picture that has all of the mounting pad dimensions of the K-Source Backup Mirror # KSC088. Basically it's 2-7/8 inches wide and 4-3/4 inches long.

expert reply by: Jameson C

1

click to enlarge

Answer 1

The #KSC088 K-Source backup mirror would work for aligning your fifth-wheel hitch and king pin, but this mirror will only allow you to see a field up to 6' behind the mirror. If your truck has a long bed, you would not be able to see the king pin…

view full answer...

Answer 2

Your current back up mirror similar to the K-Source #KSC088 that you referenced is most likely stuck on with an adhesive. What you can do is run floss or fishing line under the adhesive to separate it from the glass.

view full answer...

Answer 3

The K-Source Backup Mirror part #KSC088 is not designed for multiple uses. If the mirror has already been attached and secured, it cannot be moved to another location. The double sided adhesive tape used to attach the mirror is not rated for this…

view full answer...

Answer 4

As long as you have a relatively flat surface to mount this mirror to you should have no problem installing this K-Source Backup Mirror on your 2009 Toyota 4runner. This KSC088 mirror mounts using an adhesive, so you will not have to use any tools or…

view full answer...

Answer 5

The K-Source Backup Mirror #KSC088 is a stick-on mirror that you can put pretty much anywhere on the vehicle to gain more visibility. If you like a backup camera for your vehicle so that you can see everything behind you with ease then let me know…

view full answer...

Answer 6

The K-Source Backup Mirror - Stick On, part #KSC088, is adjustable and has a fish eye lens to give you the optimum viewing of whats behind you. The viewing range on this #KSC088 is up to six feet behind where you mount the mirror on your vehicle, and…

view full answer...

Answer 7

The adhesive on the mirror #KSC088 has a thick pad-like material that will allow it to conform to slight curves in the mounting surface. Basically the material will compress slightly to match the curvature of the window so that the adhesive will…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Mounting Pad Dimensions of K-Source Backup Mirror # KSC088

Product Page this Question was Asked From

Continue Researching