Which Install Harness Is Needed to Install P3 Brake Controller in 2017 Toyota Tundra

Question

Question:

Need the wiring harness for the 2017 Toyota Tundra

asked by: Aaron

0

Expert Reply:

The correct brake controller install harness for installing the Prodigy P3 brake controller part # 90195 in your 2017 Toyota Tundra is the part # 3031-P.

expert reply by: Jameson C

0

Answer 1

You can definitely ground your trailer brake assemblies to your trailer frame. This will be just as effective and also will be a much easier install.

view full answer...

Answer 2

The Prodigy P3 item #90195 is compatible with your 2017 Toyota Tundra. This is a proportional brake controller that activates your trailer's brakes when your Tundra decelerates. You will want to use the Custom Wiring Adapter for Trailer Brake…

view full answer...

Answer 3

The brake controller connector is clipped to the back side of a panel located just to the right of the ignition key. You'll need to lower the panel and unclip the connector from the rear of the panel, then feed it down behind the panel so it…

view full answer...

Answer 4

To wire your electric brakes you will want to run 10 gauge wire #10-1-1 to one of the brakes and run it to the other brake, using butt connectors like #05732-2 to connect them. The grounds will not be spliced, each brake assembly should have its own…

view full answer...

Answer 5

To install the Tekonsha P3 into your 2008 Tundra with the factory 7-way, you'll need the #3040-P wiring harness which plugs into the factory connector behind or above the driver's side kick panel. As long as your Tundra has the factory tow…

view full answer...

Answer 6

If you have a 7-Way on both your trailer and tow vehicle you will first want to make sure that you have a brake controller, like the Tekonsha Prodigy P3 #90195. A brake controller is what is used to send power from the tow vehicle and tells the…

view full answer...

Answer 7

Electric brakes have 2 wires located at the back. One is for power and the other is for ground (it doesn't matter which is used for which function). The ground wires should be connected to the trailer frame. The only other place that would carry…

view full answer...

Answer 8

The first step I suggest for troubleshooting your truck's trailer brake controller is to disconnect the truck and trailer and clean the connectors. If that does not correct the problem, test using a circuit tester like #PTW2992. See the linked…

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 12

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Which Install Harness Is Needed to Install P3 Brake Controller in 2017 Toyota Tundra

Featured Help Information

Miscellaneous Media

Continue Researching