Will Tuson DirecLink Brake Controller Work with International Prostar Pulling 40 Foot Trailer

Question

Question:

Will this work with this truck pulling a forty foot two axle fifth wheel?

asked by: Robert A

0

Expert Reply:

Yes, the Tuson DirecLink Base Model Trailer Brake Controller # 335DL-100 will work well for a 40 foot trailer that is equipped with 2 axles. This unit is compatible with trailers that have up to 4 axles (8 total brake assemblies).

The DirecLink will simply plug into the OBD-II port and the pigtail harness will need to be spliced into the appropriate wires on your truck (see attached image). For your International Prostar you will likely need to add either the Module Kit # 335HDCON-6PIN if you have a 6-pin Deutsch connector or # 335HDCON-9PIN if your truck has the 9-pin connector.

I have attached a couple short video reviews that you can check out as well.

expert reply by: Chris R

0

click to enlarge

Leo

4/7/2025

Will it also work on trailers equipment equipped electric over hydraulic brakes? Or only electric?

Chris R.

4/8/2025

@Leo Hey Leo! The DirectLink works with electric over hydraulic brakes, as well. If that's what you have on the trailer, you're good to go with this controller.

Answer 1

The only difference between 7-Way Utility and 7-Way RV is the color of the wires. The pin outs are the exact same so either would work just fine with the other. If you check out the picture I attached you'll see that the functions are all the…

view full answer...

Answer 2

The difference between the two is the 9-pin Deutsch connector they are compatible with; one is for green 9-pin Deutsch connectors (which have a slightly larger pin size) and the other is for the standard 9-pin Deutsch connector. So you wouldn't…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 7

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 8

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 9

Hey Jonathon thank you so much for all of that additional information! To haul your bikes behind your class C Sprinter motorhome, while flat towing your Mini, I recommend the Hollywood Racks RV Rider Bike Rack item #HLY64FR and the Roadmaster Dual…

view full answer...

Answer 10

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 11

To install a Redarc Tow Pro Liberty in your 2023 Toyota Tacoma Sport you will need the following parts: Redarc Tow-Pro Liberty Brake Controller item #RED24FR Plug-and-Play Wiring Harness for Redarc Tow-Pro Trailer Brake Controllers item #RED99FR…

view full answer...

Answer 12

Hey Jairo. So we do not offer a direct replacement for the Norcold N611, but we do have a good replacement option for you. It really comes down to what will fit in your cutout space. Take a look at the Norcold RV Refrigerator w/ Freezer - 8.2 cu ft -…

view full answer...

Will Tuson DirecLink Brake Controller Work with International Prostar Pulling 40 Foot Trailer

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching