Installation of Replacement Push-Button Switch for Ventline Roof Vent

Question

Question:

How do I change the above switch?

asked by: Garnet J

0

Expert Reply:

The Replacement Push-Button Switch for Ventline Trailer Roof Vents # BV0199-03 will have one wire as an input and one as an output. The switch simply mounts through a hole with the threaded nut on the outside where the switch and threaded housing stick through.

I've attached a photo of the Ventline Vanair Trailer Roof Vent w/ 12V Fan - 6-1/4" Diameter - Smoke # VP-543SP to assist.

expert reply by: Jason S

0

click to enlarge

Answer 1

The Jensen Touch Screen RV Stereo JRV9000R measures 7" wide x 4-5/8" tall x 6-5/16" deep overall. I wasn't able to find the dimensions of the discontinued Axxera AV614BH but if it's similar then these can be swapped out. As for…

view full answer...

Answer 2

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 3

Hi Jesus, The number you provided comes back as a Solera Edge awning in black, but we'll need a bit more information to determine the correct arm because there's 3 different models in black. There should be another sticker on the arm with a…

view full answer...

Answer 4

We had the chance to install a brake controller in a similar Ranger as your 2021 model and when using standard brake controller wiring like with the #C51515 to install the Curt Echo Mobile #C27JR the yellow/orange goes to the black wire, the blue…

view full answer...

Answer 5

Hi Dennis; you will find the wires for brake controller installation up under the dash. For whatever reason they still don't add a custom plug for plug and play installation. You can see this in the picture below and I also attached a video where…

view full answer...

Answer 6

In order to determine the correct replacement for your Lippert Edge awning you'll need to measure the length of your wall mount (see attached photo). Once you've got that number you can look for a replacement based off of that measurement.…

view full answer...

Answer 7

In order to remove the old retaining pin from the drive pin on your Solera awning you will first need to remove the cover. The Drive Head Retaining Clip #LC266137 slides into the groove on the Drive Head Pin for Solera Power RV Awnings #LC266141. You…

view full answer...

Installation of Replacement Push-Button Switch for Ventline Roof Vent

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching