Wiring Diagram for Replacement Air Gauge for Air Lift Load Controller Compressor System # AL25194

Question

Question:

Where can I find the install document for this controller? Looking to see what wire does what. Thanks

asked by: Gregory B

0

Expert Reply:

I checked with Air Lift and was able to find a wiring diagram for the Replacement Air Gauge for Air Lift Load Controller Compressor System # AL25194 and attached it to this page.

expert reply by: Jameson C

0

click to enlarge

Answer 1

Both your Tekonsha Primus IQ TK90160 and the Prodigy P3 #90195 have the same plug at the back so you'll easily be able to swap out the controllers. This will be a nice upgrade since the P3 is compatible with electric over hydraulic brake systems…

view full answer...

Answer 2

The Prodigy P2 brake controller #90885 and the Primus IQ #TK90160 share some basic features, but there are many differences. The most obvious ones are the displays and appearances of the units, which are connected to the usability of the brake…

view full answer...

Answer 3

I spoke with my contact at Air Lift and he said that the Air Gauge #AL25194 for your Compressor System features a built-in light that cannot be replaced. The only way to modify the light in any way would be to simply cut the red wire (which powers…

view full answer...

Answer 4

Hey Jacob, The Replacement Dual Analog Gauge #AL25195 can be used, as long as you have all of the wiring hooked up correctly. I was able to find a wiring diagram for this gauge and I'm attaching that photo to this page for your reference.

view full answer...

Answer 5

The gauge used with the heavy duty Air Lift compressor system, #AL25854, has 4 wires because the switch is built into the gauge. The black wire is the ground, white is the signal to the compressor, red and green are ignition power wires. I have…

view full answer...

Answer 6

It sounds like the compressor system may not be getting power or is not waking up. Depending on how the Air Lift WirelessONE Compressor System #AL25980 is wired to your vehicle you may have to do additional steps. The wiring harness has a ignition…

view full answer...

Answer 7

Hey Joe, The easiest way to install your replacement harness is to unplug one wire at a time and replace it with your new wiring harness. With that being said, I definitely can appreciate just wanting to unplug everything and start fresh. I'm…

view full answer...

Answer 8

I went and pulled a Replacement Air Gauge for Air Lift Load Controller Compressor #AL25194 to grab some dimensions to help you determine if it would fit in the gauge pod you have. The portion that would fit into the pod measure 2-1/2 long if you…

view full answer...

Answer 9

Yes we have just the replacement gauge you are looking for with the part #AL25195.

view full answer...

Answer 10

Yes, since the Replacement Dual Analog Gauge for Air Lift Load Controller Compressor System #AL25195 is a replacement gauge for the #AL25852 which is a dual path setup that allows for having two different pressure settings like you are looking for.

view full answer...

Answer 11

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 12

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Wiring Diagram for Replacement Air Gauge for Air Lift Load Controller Compressor System # AL25194

Product Page this Question was Asked From

Continue Researching