Will Any Reese Spring Bar Work with the Strait-Line Weight Distribution Systems

Question

Question:

Will these spring bars work with the dual cam system?

asked by: Josh

1

Helpful Expert Reply:

Yes, the spring bar that you have attached a photo of will work with the dual cams part # RP26002 on the Reese Strait-Line Weight Distribution Systems like part # RP66084.

expert reply by: Conner L

1

click to enlarge

Answer 1

You should not have a problem attaching the Strait-Line Weight Distribution on your 4 inch C-channel trailer frame. Per the installation instructions for part #RP26002, when installing the dual cam sway control, the note says the bottom of the frame…

view full answer...

Answer 2

The trunnion-style spring bars used in Reese Dual Cam weight distribution systems, both the standard dual cam and high-performance dual cam systems, are the same length. Trunnion spring bars are selected not based on length but by weight capacity.…

view full answer...

Answer 3

Hello Phillip, thanks for reaching out. Yes, the Reese Dual Cam #RP26002 WD system can be used with a Reese Friction Sway Control #83660. As long as the head of your WD hitch has the pre-welded tab for the sway control ball (pictured below), the…

view full answer...

Answer 4

Thank you for your photo of your Reese Dual Cam Weight Distribution system's cam mount. I spoke to my technical contact at Reese about the issue you had with the hardware and dual cam brackets coming out of their mounting positions on your…

view full answer...

Answer 5

To get the Reese Dual Cam Sway Control System #RP26002 to fit, your spring bars will need to have a curved end that the chains are attached to. Kind of hard to explain, so I did include a picture of the end of the bar this fits. With that being said…

view full answer...

Answer 6

As long as you stay under the 10,300 pound mark you should be fine. Currently your trailer and gear estimate would weigh 9,100 pounds. Take a look at the rig when the trailer and truck are fully loaded as though you were ready to hit the road. If the…

view full answer...

Answer 7

You are not missing anything and you are correct. The Reese Weight Distribution Shank #RP69FR will provide 8.75" of drop. I have included a picture that shows the drop dimensions between each hole.

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 12

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Will Any Reese Spring Bar Work with the Strait-Line Weight Distribution Systems

Continue Researching