Replacement Wheel for Dexstar 15x5" Steel Spoke Wheel 17-384

Question

Question:

Dextar 17-384 15x5JJ 2200lb

asked by: Paul

0

Expert Reply:

We do have the Dexstar 15x5" Steel Spoke Trailer Wheel 17-384 listed on our site as part # AM20428. Please note that Destar has this listed with a weight capacity of 2,150 lbs on their site so you need to plan your weight capacities to fit within that margin.

expert reply by: Jon G

0

Answer 1

Thank you for the photo of your old wheel. That is extremely helpful in this case.To answer your main question, the measurement of the bolt pattern is going to be the most important factor in replacing the wheels on your trailer. The hub bore…

view full answer...

Answer 2

Yes, for Dexstar wheel 17-384 it is a 5 on 5 bolt pattern. Not very common nowadays but we do have some options. Wheel #AM20428 is a spoke wheel with the 5 on 5 bolt pattern or the mini-mod version is #AM20446DX. We have other 15 inch wheels with the…

view full answer...

Answer 3

It looks like the previous owner of the trailer had vehicle tires installed since there are very few trailer tire manufacturers that carry a 235/75R15 size. Even though it might work for a while, trailer tires are always better to use for trailer…

view full answer...

Answer 4

It sounds like you are looking for the Dexstar Steel Mini Mod Trailer Wheel part #AM20436 which matches all the specs in the photo you attached. The manufacturers part number for this wheel is also 017-231.

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 7

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 10

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6 inch whereas the 225/75-15 fits widths that are 5 inch to 6-1/2 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

Answer 11

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 12

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Replacement Wheel for Dexstar 15x5" Steel Spoke Wheel 17-384

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching