Can Trailer Hitch be Installed on 2015 Toyota Venza With AWD All-Wheel Drive
Published 11/01/2018 >
Question:
2015 toyota venza awd limited-does the awd mechanics near the rear wheels have any bearing on mounting the hitch to the frame?
asked by: HARVEY M
Expert Reply:
A trailer hitch such as the Draw-Tite # 75663 you referenced can be installed on your 2015 Toyota Venza that has all-wheel drive but there will be specific instructions you need to follow to install the hitch.
If you take a look at the cut out of the installation instructions of this hitch (which are also linked) you can see that you are going to need to remove and then re-install the sway-bar brackets with the use of a spacer block.
I have added a link to a video installation of the Draw-Tite # 75663 hitch being installed on a 2011 Venza that has AWD so you can see exactly how it is done.
Featured Help Information
Miscellaneous Media
Continue Researching
- Search Results: trailer hitch
- Shop: Trailer Hitch
- Shop: Roof Rack
- Shop: Trunk Bike Rack
- Video: Best 2013 Toyota Venza Trailer Hitch Options
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class II - 1-1/4"
- Shop: etrailer Trailer Hitch Receiver - Custom Fit - Matte Black Finish - Class III - 2"
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Recommended Hitch and Wiring Harness for 2015 Toyota Venza
- Q&A: 2016 Toyota Venza Trailer Hitch Recommendation for Carrying Bike Rack
- Shop: Trailer Wiring
- Shop: Air Filter
- Video: Does the Thule Passage Trunk Bike Rack for 2 Bikes Suit Your 2009 Toyota Venza
- Video: Trailer Wiring Harness Installation - 2013 Toyota Venza
- Video: Curt Custom Fit Vehicle Wiring - Trailer Hitch Wiring - C56079 Review
- Shop: Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Shop: EcoHitch Stealth Trailer Hitch Receiver - Custom Fit - 2"
- Shop: etrailer Trailer Hitch Receiver - Custom Fit - Matte Black Finish - Class III - 2"
- Video: Setting up the etrailer Trailer Hitch Receiver on a 2014 Subaru XV Crosstrek
- Shop: Inno Square Bar Roof Rack for Naked Roofs - Steel - Black - Qty 2
- Shop: Curt Class II Drawbar - 2-5/8" Rise, 3-1/4" Drop - 7-1/4" Long - 3,500 lbs
- Q&A: Will the Curt Trailer Hitch for the 2010 Toyota Venza Fit with Dual Exhaust and Sway Bar
- Search Results: bleeding hydraulic brakes
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Measure for Trailer Hitch Drop
- Video: Trailer Wiring Harness Installation - 2014 Toyota Venza
- Video: Comprehensive Review: Square Drop Leg Stabilizer Jack
- Search Results: cargo nets
- Q&A: Curt or Draw-Tite Class III Hitch for 2015 Toyota Venza
- Search Results: coupon

