Cause of Tires Wearing on Inside of Snowmobile Trailer
Updated 11/04/2011 | Published 11/01/2011 >
Question:
My snowmobile trailer campout is wearing tires on the inside. Both tires are leaning in. The axle looks straight I put a straight on the out side of the axle. Could where be another reach its doing this. thanks
asked by: Jim
Expert Reply:
There could be a few things that are causing your trailer tires to wear on the inside.
It could be that at one time the trailer was overloaded and the axle has been slightly bent down.
Another possibility is that the another part of the suspension is worn out. You will want to check over the suspension components, and make sure that none of the bolts have made oval holes where they are connected. This could indicate that these parts will need to be replaced and are worn.
You will also want to check the tire pressure on your trailer tires. Special Trailer tires, (ST) tires, should be inflated to the maximum tire pressure indicated on the tire. Tires that are under-inflated can cause premature wear to the tires.
I have linked an FAQ on trailer tires.
Product Page this Question was Asked From
Loadstar ST185/80D13 Bias Trailer Tire with 13" Galvanized Wheel - 5 on 4-1/2 - Load Range D
- Trailer Tires and Wheels
- Tire with Wheel
- Bias Ply Tire
- Load Range D
- 185/80-13
- 13 Inch
- M - 81 mph
- 5 on 4-1/2 Inch
- Steel Wheels - Galvanized
- Kenda
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Shop: Dexter Trailer Idler Hub Assembly for 2,200-lb Axles - 5 on 4-1/2 - Pre-Greased
- Shop: Easy Grease Trailer Idler Hub Assembly for 2K Axles - 5 on 4-1/2 - Galvanized
- Q&A: Replacement Hub and Bearings for 1989 Tracker Boat Trailer
- Shop: Easy Grease Trailer Idler Hub Assembly for 2K Axles - 10" to 12"- 5 on 4-1/2 - Pre-Greased
- Shop: CE Smith Trailer Idler Hub Assembly w/ Case for 3.5K Axles - 5 on 4-1/2 - Galvanized - Pre-Greased
- Shop: Replacement Bearing Kit with Bearings L44649, Races L44610, Seal 10-9 - Fits 1.063" Spindles
- Shop: BTR E-Z Lube Spindle for 2,000-lb Trailer Axles - 1-1/4" Diameter
- Search Results: trailer axles
- Q&A: Looking For 5 on 4-1/2" Dexter Hub For Triton Snowmobile Trailer
- Q&A: Replacement Hub for Triton Snowmobile Trailer
- Shop: 2" Lubed Dust Cap & Rubber Plug - 1.99" x 1.40" x 1.18" - Qty 1
- Q&A: Trailer Tires Showing Excessive Wear on Inside Edges of Tread
- Q&A: Trailer Tires are Wearing On the Inside Tread with Low Miles on the Tires
- Q&A: Tire Recommendation for ST215/75R14 in Load Range D
- Search Results: trailer hitch
- Video: Firestone Ride-Rite Air Bags with Easy Mount Compressor Feature Breakdown
- Shop: Trailer Hitch
- Article: Trailer Wiring Diagrams
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Shop: Trailer Wiring
- Search Results: trailer tires and wheels
- Search Results: trailer wiring
- Shop: Suspension Enhancement
- Article: How to Measure for Trailer Hitch Drop
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Shop: Brake Controller
- Search Results: trailer jack
- Video: Review of etrailer Trailer Hubs and Drums - Hub with Drum - AKHD-545-35-EZ-K
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)


