Recommended Front Mount Trailer Hitch Receiver for 2008 Dodge Ram 3500
Published 10/30/2018 >
Products Featured in This Question
Question:
Thanks for the quick reply, I would like to ask one more question if I may and that is this: Is there a front hitch that would allow the receiver box to go thru the air dam to gain a bit more ground clearance, rather than under it ?
asked by: Craig
Helpful Expert Reply:
The Draw-Tite Front Mount Trailer Hitch Receiver - Custom Fit - 2" # 65063 is not a fit for your 2008 Dodge 3500. It will only fit 2010-2018 models.
For your 2008, I recommend the Draw-Tite Front Mount Trailer Hitch Receiver - Custom Fit - 2" # 65046 which is a fit and will give you a 500 lb vertical load rating and 9,000 lbs line pull rating. I've attached an installation video to assist.
Featured Help Information
Miscellaneous Media
Continue Researching
- Shop: Front Mount Hitch
- Search Results: truck camper tie downs
- Video: Installation: Draw-Tite Front Mount Trailer Hitch Receiver on a 2015 Ram 2500
- Search Results: front receiver hitch
- Q&A: Which Front Hitch Fits 2019 Ram 2500 Laramie
- Shop: Curt Front Mount Trailer Hitch Receiver - Custom Fit - 2"
- Shop: Draw-Tite Front Mount Trailer Hitch Receiver - Custom Fit - 2"
- Search Results: anti~sway bars
- Shop: Camper Tie-Downs
- Video: Review of Draw-Tite Front Receiver Hitch - Custom Fit Front Mount 2 Inch Trailer Hitch - 65046
- Shop: Trailer Hitch
- Q&A: Dimensions of Cross Tube on Front-Mount Hitch 65063 for Installation of LED Light Bar
- Shop: HappiJac Original Turnbuckles for Camper Tie-Downs - Stainless Steel - Qty 4
- Shop: TorkLift Locking FastGun Turnbuckles for Frame-Mounted Tie-Downs - Stainless Steel - Gray - Qty 4
- Shop: HappiJac Camper Tie-Downs - Custom Bed and Bumper Mount - Front and Rear
- Shop: Brophy Basic Turnbuckles w/ Hardware for Camper Tie-Downs - 3,000 lbs - Qty 4
- Q&A: Dimensions for Draw-Tite Front Mount Trailer Hitch Receiver # 65063
- Search Results: atwood jack parts
- Search Results: atwood trailer jack
- Shop: Replacement Aluminum Gearbox for Stromberg Carlson Landing Gear
- Q&A: Motor and Gear Box Recommendation for Atwood Landing Gear 75722
- Q&A: Recommended Replacement Motor for Atwood Trailer Tongue Jack
- Q&A: Are There Replacement Gears Available for the Tongue Jack for Lippert Ground Control LC421366
- Q&A: Differences Between Curt C31017 and Draw-Tite 65046 on 2007 Dodge Ram Truck


Craig
10/30/2018
Thanks for the quick reply, I would like to ask one more question if I may and that is this: Is there a front hitch that would allow the receiver box to go thru the air dam to gain a bit more ground clearance, rather than under it ?