Will Drilling into Trailer Frame for Chain Hanger Brackets RP58305 Weaken the Frame
Updated 09/17/2018 | Published 09/15/2018 >
Question:
I bought a weight distribution hitch and there is a cross support in the way of the snatch up hangers so the chains would be at a slight angle. I want to buy this part as a solution but am concerned that drilling thru the tongue will weaken the trailer frame. Is this a valid concern? Trailer is a 2019 palomini with a dry hitch weight of around 400lbs
asked by: Larry
Expert Reply:
The trailer manufacturer may have something to say about drilling into the sides of the frame but if they are fine with it then you are good to go with chain hangers # RP58305. A steel frame would still be fine if you drilled into it. Aluminum can be an issue unless the manufacturer says it is fine to do so.
When you say a slight angle, how far off from being straight are the chains? If it is slight enough you may not have to use alternate brackets.
Featured Help Information
Miscellaneous Media
Continue Researching
- Shop: Brake Controller
- Shop: Lippert Quick Drop Tongue Trailer Jack - A-Frame - Topwind w/ Drive Nut - 14" Lift - 2,000 lbs
- Video: Hands-On with the Lippert Quick Drop Tongue Jack
- Search Results: trailer hitch ball mount
- Shop: Trailer Valet JX Drill Powered Jack - Pipe Mount - 14-1/2" Lift - 1,800 lbs
- Shop: Square A-Frame Trailer Jack w/ Footplate - Drop Leg - Sidewind - 15-1/4" Lift - 3,000 lbs
- Search Results: tekonsha prodigy rf
- Q&A: Male Pipe Dimensions for Installing Square Pipe Mount Swivel Jack on Trailer
- Search Results: trailer hitch
- Shop: Curt Short-Arm Weight Distribution System with Shank - Trunnion Bar - 10,000 lbs GTW, 1,000 lbs TW
- Video: A Closer Look at the Trailer Valet JX Trailer Jack
- Video: Review of etrailer Bolt on Swivel Jack Mounting Plate - e52JR
- Article: 2 Steps for Finding the Right Weight Distribution Hitch Size
- Article: 5 Things to Know About Weight Distribution Hitches
- Shop: etrailer Swivel Jack w/ Bolt-On Mounting Plate - Sidewind - 10" Lift - 3,000 lbs
- Shop: etrailer 2 Swivel Jacks w/ Bolt-On Mounting Plates - Sidewind - 10" Lift - 3,000 lbs
- Shop: Trailer Valet JXS Drill Powered Swivel Jack w/ Footplate - 14" Lift - 1,600 lbs
- Video: Breaking Down the Chain Hangers for Curt Weight Distribution Systems
- Video: Feature Review B and W Tow and Stow 2-Ball Mount
- Video: Test Fitting the B&W Tow & Stow 2-Ball Mount on a 2024 Chevrolet Colorado
- Video: An In-Depth Look at the B and W Tow and Stow 2-Ball Mount
- Search Results: ark xo
- Search Results: curt echo button
- Search Results: 3 inch drop hitch
- Search Results: hitch pins and clips
- Q&A: Recommended Trailer Mounting Location for Prodigy RF Brake Controller
- Q&A: Can Tekonsha Prodigy P2 Trailer Brake Controller be Mounted Backwards
- Q&A: Can You Drill Into An Aluminum Trailer To Install The CargoSmart D-Rings
- Article: Trailer Wiring Diagrams
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
