Replacement Landing Gear Motor Recommendation for 2010 Keystone Laredo

Question

Question:

I am looking for a replacement landing gear motor for my 2010 keystone Laredo 5th wheel. I’m not sure which motor it takes.

asked by: Sylvia

0

Expert Reply:

Most Keystone fifth wheel trailer have standard Lippert/Venture/Stromberg style landing gear sets so the motor part # LG-142178 that you referenced should be the right kit. If you have something different let me know. If what you have looks like the picture I attached this would be the correct motor.

expert reply by: Jameson C

0

click to enlarge

Answer 1

Most likely yes, but you'd need to measure the current mounting brackets of your landing gear to know if the #RVLG-8000 is going to fit and work well. Compare the measurements to the picture I attached and if your mounting brackets match this kit…

view full answer...

Answer 2

I reached out to my contact at Lippert and since your landing gear motor is blowing a fuse as soon as it sees load he mentioned the issue is more than likely that the motor is not getting the correct voltage, with the less common cause being the…

view full answer...

Answer 3

For your replacement stereo, I recommend the Jensen Stereo -AM/FM - CD/DVD - USB - Bluetooth #JWM60A. It as rough opening dimensions of 9 inches by 6 inches by 5-1/2 inches and is the best option for a replacement in my opinion. It will be a nice…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 9

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 10

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 11

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 12

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Replacement Landing Gear Motor Recommendation for 2010 Keystone Laredo

Product Page this Question was Asked From

Continue Researching