Rung Step Dimensions on Surco RV Bunk Ladder

Question

Question:

Thank you for answering my question. Is there a bunk ladder with wider rungs- wider than 2 in?

asked by: Adele

1

Helpful Expert Reply:

The Surco RV Bunk Ladder # SP503B has rungs that measure 12-3/4 inches long with 10 inches in between the tubes and 2 inches wide but with the plastic covers 2-1/4 inches. There is 12 inches between the rungs.

expert reply by: Jason S

1

click to enlarge

Adele

8/10/2018

Thank you for answering my question. Is there a bunk ladder with wider rungs- wider than 2 in?

Jason S.

8/10/2018

We carry both Stromberg Carlson and Surco bunk ladders and all of them have the same rung width of 2 inches. They are strong and the Stromberg Carlson model # LA-460 most similar to the Surco model you asked about originally is rated for 200-300 lbs. These ladders use the same rungs as the RV exterior ladders you see on the back of trailers and motorhomes. They are 12-3/4" long x 2" wide x 3/4" thick.

Answer 1

The photo you attached did not come though but I have attached for you a list of all the bunk ladders that we offer. If you need one with hooks then I recommend the Surco RV Bunk Ladder part #SP503B which is 60" long x 12" wide but you can…

view full answer...

Answer 2

The bottom rung on the Surco RV Bunk Ladder, part #SP503B is 12-inches from the bottom. You can remove the bottom caps and the bottom rung and cur the ladder to your desired height. The bottom rung cannot be installed on the ladder legs other than in…

view full answer...

Answer 3

Relatively speaking yes, you'll just swap out your GE AC with a different AC like the Advent Air RV Air Conditioner #ACM150 with the Air Distribution Box w/ Built-In Thermostat for Advent Air RV Air Conditioners #ACDB as your existing…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 8

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 9

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 10

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 11

Hey Ricardo! Yes, the Curt Trailer Hitch Receiver #C82RJ is the hitch Curt is working on for the new 2027 Telluride. This is a pre-order since Curt hasn't finished the design. It does not include wiring. The wiring harness for the 2027 is also up…

view full answer...

Answer 12

Hi David! There are quite a few hitches offered for your 2026 Honda Odyssey, so I definitely understand wanting to know the differences. There are basically three styles available for you and I have them broken out below: Exposed Crosstube: etrailer…

view full answer...

Rung Step Dimensions on Surco RV Bunk Ladder

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching