Replacement Yakima Skybox 16 Lid Support

Question

Question:

You have listed a front support for the Yakima skybox 8870090 what number is for the rear support? Or are they universal Front/Rear?

asked by: Norman C

0

Expert Reply:

The Replacement Front Lid Support for Yakima SkyBox 12 and SkyBox 16 Rooftop Cargo Boxes 2009 and Newer # 8870090 is universal for the front and rear. I've attached a couple photos of the installation instructions to assist.

expert reply by: Jason S

0

click to enlarge

Answer 1

I checked with Yakima and for your Skybox 16 the correct lid support for the rear is supposed to be part #8870072 and for the front is part #8870090. The picture you submitted shows a broken or twisted part #8870090 so that is what you'd need as…

view full answer...

Answer 2

The Replacement Rear Lid Support for Yakima SkyBox 12 and SkyBox 16 Rooftop Cargo Boxes 2009 and Newer 8870088 was originally attached with the rivets you have attached a picture of. The new support comes with screws that are used instead. You can…

view full answer...

Answer 3

You can buy the front and rear lid supports for your Yakima SkyBox 18 #Y07336 right here! For the front lid support you need Replacement Lid Support #8880684 while for the rear lid support you need Replacement Lid Support #8880683.

view full answer...

Answer 4

To replace the latch on the Yakima SkyBox 18 Rooftop Cargo Box item #Y07336 you will want the Replacement SuperLatch Handles for Yakima SkyBox Cargo Boxes item #Y8880348. This comes with two latches so that you can replace both and have matching lock…

view full answer...

Answer 5

I spoke with Yakima and they said that you need to push down on the box just above where the handles are on both sides. If you are able to do this then engage the locks back and forth as that should then allow you to open your box. According to…

view full answer...

Answer 6

All Yakima Skyboxes 2009 to current, like #Y95AV, feature SuperLatch security latches on both sides, so if one of your lock cores fell out, and you lost one of the lock cylinder housing components, the only solution is to replace the SuperLatch…

view full answer...

Answer 7

For starters, there are a few different generations of the Yakima SkyBox 16 and I would need to know which one you have in order to recommend the correct replacement hinges. I called Yakima and they were not able to reference the part number you…

view full answer...

Answer 8

I checked with Yakima and for the SkyBox 21 made from 2009 to present the lift struts are part #8880683 for the rear and #8880684 for the front.

view full answer...

Answer 9

It is very difficult to diagnose what the issue may be without knowing a model number and seeing photos but it sounds like the latch on the locking mechanism on your RocketBox may have somehow been damaged. I would need to know the model number in…

view full answer...

Answer 10

Yakima recommends the use of a rubber mallet to get the ball into the socket of the #8880683. Since plastic is a bit more flexible when warm you might take a heat gun or blow dryer to warm everything up and allow it to fit easier.

view full answer...

Answer 11

I did some research and it looks like your 2022 Toyota Sienna has adjustable aero crossbars. The Yakima SkyBox NX 16 Roof Cargo Box item #Y95AV. is compatible with aero cross bars and fits a crossbar spread of 24" - 36". This means how far…

view full answer...

Answer 12

It sounds like you are needing the lid supports for your Yakima SkyBox 16, part #Y07335. We have that here. It's part #8880683. These may look a bit different than what you are used to, but that is because Yakima has updated their supports. This…

view full answer...

Replacement Yakima Skybox 16 Lid Support

Continue Researching