Highest Capacity Hitch Ball with 2 inch Diameter with 1-1/4 inch Diameter Shank

Question

Question:

Is there a ball thats 2 inch in diameter 1-1/4 in shank diameter 12000lb GTW I only see one for 10k

asked by: Darryl

0

Expert Reply:

The highest capacity 2 inch hitch ball we have that has a 1-1/4 inch shank diameter is the Curt hitch ball part # A-90.

For a 12k capacity with a 1-1/4 inch shank you'd need a 2-5/16 inch ball like the part # 19286.

expert reply by: Jameson C

0

Answer 1

I do have an option for you but the Reducer Sleeve for Super Titan Hitch Receivers part #38735 does not work with any of the Ford OEM 3" Hitches. Instead, I recommend the Buyers Products 3" to 2" Receiver Tube Adapter part #337RTA302…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 5

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 6

Hey Cody! The brake controller I recommend for your setup is the Redarc Tow-Pro Liberty Brake Controller #RED74CR. The Liberty is simple, reliable, and has a really clean look once installed. The main unit is hidden so the only thing you see is the…

view full answer...

Answer 7

Hi Collin, welcome back! The most economical replacement is going to be from Advent Air. You will need a complete system since everything moved to R32 refrigerant. If your upgraded thermostat is R32 compatible, or a smart thermostat that got a…

view full answer...

Answer 8

Hey Adam! All of the Blue Ox SwayPro weight distribution systems like #BXW0550 come with a 2-5/16" ball. The SwayPro uses a ball with a 1-1/4" diameter, and it can be replaced. You can pick up the Curt #A-90 separately and install it so the…

view full answer...

Answer 9

While we do not have the exact Lippert hub/drum we do have the Dexter #K08-201-98 equivalent. This hub has the same 6 on 5-1/2" bolt pattern and fits the same size spindle. The hub includes all new bearings, races, spindle nut, retainer, grease…

view full answer...

Answer 10

Hey Nancy, yes the WFCO Auto Detect RV Converter and AC/DC Distribution Panel #WF96FR that you referenced is the correct replacement for your WF8735P that you have now and is compatible with lithium batteries like you need as well. This is same shape…

view full answer...

Answer 11

The Curt TruTrack Weight Distribution System part #C17500 which is rated for up to 10,000 lbs gross trailer weight and 1,000 lbs tongue weight would work but it wouldn't perform as well as the Curt TruTrack Weight Distribution System part #C17499…

view full answer...

Answer 12

Curt recommends the use of 250 ft. lbs of torque when tightening the nuts on their hitch balls like #C40034. The general rule is for a 3/4" shank tighten to 150 ft. lbs, for a 1" shank tighten to 250 ft. lbs, and for a 1 1/4" shank 450…

view full answer...

Highest Capacity Hitch Ball with 2 inch Diameter with 1-1/4 inch Diameter Shank

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching