Replacement Breakaway Switch for 2013 Rockwood Freedom Camper Trailer

Question

Question:

I have a 2013 rockwood freedom tent camper and the break away switch go hooked on something and I need to replace it

asked by: Walter O

0

Expert Reply:

Breakaway switches are universal parts so I recommend using the Replacement Breakaway Switch with Cable and Pin # 3802348. This has 4' long cable and 2 wires and is going to work for you; I've added a link to a video review of this switch for you to check out.

expert reply by: Kyle S

0

Answer 1

If the door hinge on your 2005 Winnebago Vectra has a similar design then yes, the Replacement Controlled Motion Hinge for RV Entry Door - 6 Leaf #LC95VR will work as a replacement. This is a universal product that has an overall length of…

view full answer...

Answer 2

Hey Steve, thanks for reaching out! The Roadmaster Direct-Connect Base Plate Kit #RM87NQ fits your 2025 Ford Maverick as long as it's the Hybrid model that doesn't have the engine block heater. It doesn't come with the 6-Pin connector,…

view full answer...

Answer 3

Hi Mark, I totally get how frustrating that must be especially after choosing the Maverick for flat towing. I did find some updated info I can share with you, but the best way to stay on top of things for your specific vehicle is to use Ford’s…

view full answer...

Answer 4

Hey Rick, I went through the install instructions of the Roadmaster Direct Connect base plate kit part #RM97RR and you actually trim out a whole in the shutters and reinstall them. They are not totally removed. Do you have a tow bar already?

view full answer...

Answer 5

Yes, it does Gary! The Blue Ox Base Plate Kit item #BX2914 has been confirmed to fit the 2025 Ford Maverick hybrid. I have linked a installation video below along with the instructions so you can see how to get it set up. If you have any additional…

view full answer...

Answer 6

Hey Larry, we do have the Roadmaster base plate kit part #RM87NQ that is a confirmed fit for your 2025 Ford Maverick Hybrid. Since you have a Blue Ox tow bar you'd also need the adapter part #BX88185.

view full answer...

Answer 7

Pushing the pin back into the breakaway switch should allow the brakes of the trailer to release. You may have to back the trailer up slightly to get the brakes to release. If you have tried that and are still having problems you may need to replace…

view full answer...

Answer 8

If you still have the plunger end that goes in the break away switch, then you can simply insert the plunger back into the switch and that should cut off the power to the brakes on your trailer. If you no longer have the plunger, then you can either…

view full answer...

Replacement Breakaway Switch for 2013 Rockwood Freedom Camper Trailer

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching