Recommended Brake Controller For Fleetwood Excursion

Question

Question:

I need a brake controller for a 2006 Fleetwood Excursion towing a Featherlite Car Hauler with 7k GVW. What controller do you suggest and when can I expect to receive it? T

asked by: Denny S

0

Expert Reply:

I recommend our Tekonsha Prodigy P3 Trailer Brake Controller # 90195. This brake controller can control trailer brakes on up to four axles of trailer brakes. This is an ideal solution for towing small trailers, all the way up to large trailers. Being a proportional brake controller, it'll give you the braking power relative to the braking power that's being applied in your Fleetwood Excursion that's doing the towing, so your Featherlite Car Hauler stops evenly and smoothly behind you.

To install the brake controller you will need to plug in # 3027-P on one end of the adapter into your brake controller and then plug the other end into the built-in harness beneath your vehicle's dash.

expert reply by: Timothy G

0

Answer 1

Hey Anthony, It looks like there's a proprietary pigtail wire harness (p1072586) to connect to the factory plug behind the trim on the driver's side and the brake controller's wire harness. From what I can find some people say that…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 6

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 7

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 8

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 9

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 10

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 11

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 12

Hi David! There are quite a few hitches offered for your 2026 Honda Odyssey, so I definitely understand wanting to know the differences. There are basically three styles available for you and I have them broken out below: Exposed Crosstube: etrailer…

view full answer...

Recommended Brake Controller For Fleetwood Excursion

Featured Help Information

Miscellaneous Media

Continue Researching