Roof Rack Recommendation for Enclosed Cargo Trailer

Question

Question:

Thanks. Here are some pictures. I was thinking of running a flat steel bar under the 4 internal supports and then attaching a rack through the roof and into the flat bar. Just not sure what rack would work.

asked by: Donna A

0

Expert Reply:

I'd have to see the roof so that I could send it to our roof rack manufacturers to see what would be the best.

expert reply by: Jameson C

0

click to enlarge

Donna A.

5/1/2018

Thanks. Here are some pictures. I was thinking of running a flat steel bar under the 4 internal supports and then attaching a rack through the roof and into the flat bar. Just not sure what rack would work.

Jameson C.

5/1/2018

Thanks for the pic! From that I can tell that the RackEm Ladder Rack part # RA-28 would fit and work well. I attached a picture of this rack installed on an enclosed trailer just like yours as well as an install video for you to check out too.

Answer 1

The Rackem Fitz-All Enclosed Trailer Ladder Rack #RA-28 does adjust horizontally to allow it to fit trailer roofs from 4-feet to 8-1/2-feet wide but its height is fixed based on the position of the roof rain gutters, which are required in order to…

view full answer...

Answer 2

The Rack'em Fitz-All Enclosed Trailer Ladder Rack #RA-28 that you referenced can indeed be cut down a bit to bring the crossbars closer to the roof of the trailer. When we installed the system we cut down the support by about 5 inches and this is…

view full answer...

Answer 3

We have the Rack Em Enclosed Cargo Trailer Ladder Rack part #RA-28 which will attach to your trailer's rain gutters and give you a set of crossbars that your kayaks could install onto. I attached an install video and picture for you to check out…

view full answer...

Answer 4

Hardware is included with the Rack'em Fitz-All Enclosed Trailer Ladder Rack #RA-28. I have included a picture of it for you.

view full answer...

Answer 5

Hey Nate, We do not have a 3/4" spindle nut or washer, the smallest option is the 7/8" spindle nut #165931and a 1" washer #SW1000. I cannot find anything smaller. Are you sure the threads on you're spindle are 3/4"? If they…

view full answer...

Answer 6

Yes, we do have a roof rack that will work with the rounded roof on your Interstate cargo trailer. It is the Rack'Em Fitz-All Enclosed Trailer Ladder Rack item #RA-28. This roof rack has a 400 lbs capacity and mounts to the side of your trailer…

view full answer...

Answer 7

Hey Steven, I was able to find out that the center cap part number you mentioned is for a 3.75 inch diameter wheel pilot hole so for a suitable replacement we carry the #KE95JV which would work great. Did yours break or did they fall off?

view full answer...

Answer 8

Hey Doug. So long as your Husky 5th wheel hitch isn't three decades old you shouldn't have any issues attaching it to the B&W Custom Installation Kit w/ Base Rails item #BWRVK2402. Most 5th wheel hitches for the last 20 years have used…

view full answer...

Answer 9

Hey Greg! Where did your Stromberg Carlson Base Pad Extreme #SC53VR crack? The Andersen Trailer Jack Block #AN39VR is a good alternative. It has the same 6,000 lb capacity and the design is a little more basic/straightforward which makes it less…

view full answer...