Difference Between Scissor Stabilizer Jacks for RV

Question

Question:

Hi, Are the stabilizer/trailer mounts on the scissor stabilizers the same regardless of the size?

asked by: Chuck

0

Expert Reply:

A few of our scissor jacks have different weight capacities. For example, the part # UF48-979002 has a 6,500 lb capacity, the part # TJSC-24 has a 2,500 capacity and the # JSC-24-IND has a 5,000 lb capacity.

expert reply by: Jameson C

0

Robert F.

3/4/2020

I lubed the scissor Jacks on my 5th wheel with a silicone lube and now they dont hold. After putting tension on them they begin to unwind . What should I clean them with if anything. Never had this happen before. Thanks

Chris R.

3/5/2020

It sounds like the jack screw may be just a bit over-lubricated. Try spraying some carb cleaner on the mechanism near the fitting to see if this helps. It might be something that resolves itself over time too as some debris or rust develops around the screw.

Answer 1

Congrats on the new motorhome Edward! SnapPad doesn't have the 2026 Allego Red 38 KA in their system so I don't know what size your jack feet are. However, we have a few options that will work with the HWH leveling systems. What you'll…

view full answer...

Answer 2

The difference between the prices of the JR Products Automatic Changeover LP Gas Regulators and Camco Automatic Changeover 2-Stage Propane Regulators are in the BTU per hour, which as you correctly noted, is important information. The JR Products…

view full answer...

Answer 3

Hey Mark, To plug the unused ports on your JR Products RV LP Gas Manifold #JR65CR you'll just need the JR Products RV LP Gas Manifold Plug #JR25CR. We also offer a couple of adapters to make your connection to the ports easier: 1/2" x…

view full answer...

Answer 4

Hey Jeff! The best option for a self-leveling sealant is definitely Dicor. This is probably the number one name in that space, and is compatible with EPDM, TPO, PVC, DiFlex II, and BriTEK roofing materials. There are a variety of colors available,…

view full answer...

Answer 5

The Ultra-Fab Ultra Scissor Jacks #UF48-979002 will replace the standard 24" jacks that come on your 2018 Grand Design Imagine 2150RB travel trailer. If you find that the jacks are constantly needing blocks to make up the additional height to…

view full answer...

Answer 6

Hey Llyod, the etrailer scissor jack part #e29VV that you referenced weighs 8 lbs. Are you close to the GVWR of your trailer?

view full answer...

Answer 7

Hey Doug, welcome back! The Leveling Scissor Jack - 24" Lift - 5,000 lbs item #JSC-24-IND and the Scissor Stabilizer Jacks - 18-3/4" Lift item #TJSCHD-24 are going to be made of the same 14 gauge steel. The difference in capacity has to do…

view full answer...

Answer 8

To replace the standard 24" scissor jacks on your 2019 North Trail 22CRB you can use the Leveling Scissor Jack Set #JSC-24. If you typically need blocks to make up the additional height to the ground you can switch to 30" jacks with the…

view full answer...

Answer 9

To check the pins on the vehicle side 7-Way, you can use a circuit tester or the volt meter. The circuit tester will show you if a signal is coming through on the pin you are testing while the volt meter will tell you that and how much voltage is…

view full answer...

Answer 10

If you're wanting to replace your Dometic 300 RV toilet then I recommend sticking with the 300 line with the Dometic 300 Weekender RV Toilet #DOM64FR so that your size stays the same and so your water inlets are still in the same spot so that you…

view full answer...

Answer 11

The Leveling Scissor Jack Set part #JSC-24 can be mounted on a motorhome yes. In regards to installation, the jack will need to be attached to a part of the frame but there aren't many other mounting restrictions. However, I do recommend you…

view full answer...

Difference Between Scissor Stabilizer Jacks for RV

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching