Which Baby Moon Cover Fits Over Mounting Tabs that are 10-1/4 inch in Diameter

Question

Question:

1957 aloha travel trailer. Measures 10 1/4 from top of tab across to outside of inner ring. Measures 10 1/8 inner ring, no tabs. 5 lug, 15 rim. What will fit ? Thanks

asked by: Jerry S

0

Expert Reply:

If the outside of the mounting tabs for a baby moon cover on your wheel measures 10-1/4 inches then the Baby Moon Cover part # AM981306 will fit and work well. These have an inner diameter of 10-1/4 inches.

Normally these will only fit 6 lub wheels so yours being 5 lug makes it harder to say for sure.

expert reply by: Jameson C

0

Answer 1

We have one potential option for your 15 inch wheels, though they do have an inside diameter of 10-1/4 inches, which is close enough to 10-3/8 inches that I did want to at least mention it in case you just want to verify your measurement. The option…

view full answer...

Answer 2

Based on the measurements of your wheel you included it appears you will need the Phoenix USA Baby Moon Hubcap #PX1307SS. This hubcap has an outer diameter of 10-1/2" with an inner diameter of 10-3/8" and a lip that is 10-3/16" across.…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 7

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 8

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 9

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 10

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 11

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 12

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Which Baby Moon Cover Fits Over Mounting Tabs that are 10-1/4 inch in Diameter

Product Page this Question was Asked From

Continue Researching