Replacement Front Driver-Side Latch for Extang Revolution Soft Tonneau Covers

Question

Question:

I have a revolution tonno cover soft on a 2009 Silverado. The latch by the drivers side door needs replaced. Im confused as to what is the front and rear of the cover. What part do I need the front or rear latch. Thanks

asked by: Joe S

0

Expert Reply:

The latch near the driver-side door of your 2009 Silverado would be the front latch. All of the latches for the Extang Revolution soft tonneau covers are position-specific so you do need the exact one for each location on the vehicle.

For the front driver-side latch you will need part # EX1093. This part fits Revolution covers for all truck bed lengths.

expert reply by: Adam R

0

Answer 1

I cannot find anything on the Extang cover you have, unfortunately. It sounds like the cover you have is an OEM part for the Ford Raptor. Without truly knowing what cover it is it's going to be pretty difficult to find the correct replacement.…

view full answer...

Answer 2

The #EX1072 fits the Extang Express but not the Revolution EX54790 that you have. I contacted Extang and the correct part for your cover is #EX1091.

view full answer...

Answer 3

You can use both the RoadActive Suspension Enhancement Kit #RAS4611 and the Timbren Suspension Enhancement Kit #TGMRCK25D at the same time. The Roadmaster kit will take care of the travel the initial travel of your suspension, the Timbren will just…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 7

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

Hey Donny! For your Dometic Penguin/Brisk Air 15,000 BTU AC model B59516.711C0-MX, the correct soft start is the #DMC93JF. This is designed for Dometic Brisk II electronic air conditioner units with in-wall thermostats.

view full answer...

Answer 10

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Replacement Front Driver-Side Latch for Extang Revolution Soft Tonneau Covers

Products Featured in This Question

Continue Researching