Steering Stabilizer for a 2008 Ford E-450 Class C Motor Home

Question

Question:

LOOKING FOR STEERING STABILIZER FOR MY 2008 FORD E450 CLASS C MOTOR HOME CAN YOU HELP

asked by: JOHN S

0

Expert Reply:

The Roadmaster Reflex Steering Stabilizer with Mounting Brackets, # RM-RBK24-RSSC, that you have referenced is the correct part you will need according to Roadmaster. Roadmaster also states that the estimated installation time is 1 hour and there is no drilling involved.

expert reply by: Michael H

0

Answer 1

You can use the RV Propane Gas Detector #RS64FR (white) or #RS44FR (black) to replace your current Atwood 31013 propane gas detector. This will also use a 12v, 2-wire installation like your current detector.

view full answer...

Answer 2

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 3

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 4

Hello Sam; that is a great question! I reached out to Furrion and you will be able to use the Furrion Chill Cube #FR69TD (white) or #FR49TD (black) with your furnace. However, the remote is not capable of operating the furnace at this time. Also, we…

view full answer...

Answer 5

Hello Joe, Thank you for reaching out! The Power Mountain Tallboy Off-Road Bottle Jack - 11-5/16" to 27-1/16" Lift - 12 Tons #PM94FR does have the capacity you’d need, but since your fifth wheel’s frame sits about 25" off the ground,…

view full answer...

Answer 6

If you just need the gearbox, the linkage will have an A, B, or C. Once you know which one you have, then you will need one of the following: Lippert Components Kwikee Step Gear/Linkage with A #LC379160 Lippert Components Kwikee Step Gear/Linkage…

view full answer...

Answer 7

Hello Bruce, Thanks for writing in! Using butyl tape between the trailer body and the Single Axle Jeep Style Trailer Fender - Diamond Plate Aluminum - 13" to 15" #HP96VR is exactly the route I would go. It stays flexible, creates an…

view full answer...

Answer 8

Congrats on the new motorhome Edward! SnapPad doesn't have the 2026 Allego Red 38 KA in their system so I don't know what size your jack feet are. However, we have a few options that will work with the HWH leveling systems. What you'll…

view full answer...

Answer 9

There is a frame available for a Kwikee single step, the Lippert Components Kwikee Step Frame 28 #LC3747457. This is a replacement frame for the Kwikee 28 Series Single Step #LC3747452, which has a mounting bolt pattern of 6.5" x 22".

view full answer...

Answer 10

Hey Eric, I can't find anything under 34-140, but maybe you meant 31-140 which is the silver Safe-T-Plus Steering Stabilizer #ST39VR. This is for Class B, C Motorhomes, Leisure Travel & Custom Vans, Pickup Truck, SUV, and Van Tow Vehicles,…

view full answer...

Answer 11

For your Reese Goose Box 5th-Wheel-to-Gooseneck Air Ride Coupler Adapter - Lippert 1621 and 0719 - 20,000 lbs #RP94720 you will need the Air System Service Kit for Reese Goose Box 5th Wheel to Gooseneck Air Ride Coupler Adapter #RP86007 which will…

view full answer...

Answer 12

Hello Lee, thanks for reaching out. If air won't go in at all it could be a bad/clogged valve. You could also have a major leak somewhere. Have you tried a soap test to see if there are any leaks?

view full answer...

Steering Stabilizer for a 2008 Ford E-450 Class C Motor Home

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching