Is U-Bolt from Reese Chain Kit # 55630 the same Size as U-Bolt from the Reese Chain Kit # 3216

Question

Question:

I was wondering if the Drawtite 3216 had the same size ubolts as the Reese 55630. I like the Drawtite kit better and looks like a better value. Thanks.

asked by: Bill

0

Expert Reply:

Yes, the u-bolts from the Reese Replacement Chain Kit # 55630 are the same size as the Reese Replacement Weight Distribution Chain Kit # 3216.

Both of the u-bolt sizes are 3/8 inch.

expert reply by: Jameson C

0

Answer 1

I went out to the warehouse and measured the U-bolt, part #3371302360. It's a course thread 3/8-16 bolt that measures about 1-15/16 inches long and has about a 1/2 inch opening. If there are other measurements you need let me know what you're…

view full answer...

Answer 2

Hey Mike, thanks for reaching out! You're looking at 1" between the centers of the U-Bolt included in the Reese Replacement Chain Kit for Uplift Bracket #55630. Please note that this kit is a direct replacement for Reese Heavy Duty Round Bar…

view full answer...

Answer 3

The correct replacement U-bolt kit for the Blue Ox SwayPro weight distribution system is the following: - Replacement U-Bolt Kit for Blue Ox Weight Distribution Spring Bars #BLU48FR

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 9

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 10

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 11

Hey Melanie. The reason you can't find a replacement for your GE ARC15AACBL2 15,000 btu air conditioner is because they phased them out. In 2025 all RV AC systems had to change over to a new coolant called R32. This was a EPA mandated decision.…

view full answer...

Answer 12

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Is U-Bolt from Reese Chain Kit # 55630 the same Size as U-Bolt from the Reese Chain Kit # 3216

Continue Researching