What is the Capacity of a 16" x 6" Trailer Wheel with 8 on 6-1/2 Bolt Pattern

Question

Question:

Thank you for the help! The wheels are so rusted that I can’t read the information. I do know the tires have no offset they are just standard 8x6.5 wheel. And the tire size is 235 with load range E

asked by: Thomas G

0

Expert Reply:

I will be happy to help. The first place to look is on the wheel itself. Sometimes the capacity is stamped into the back side of a wheel or there could be a sticker with this information on it.

If that information is not available please let me know the tire size and load range along with the bolt pattern of the wheels and I can narrow it down for you.

expert reply by: Michael H

0

Thomas

1/26/2018

Thank you for the help! The wheels are so rusted that I can’t read the information. I do know the tires have no offset they are just standard 8x6.5 wheel. And the tire size is 235 with load range E

Michael H.

1/26/2018

Thanks for getting back to me. So based on the information you have provided you have 16 inch wheels that are likely 6 inches wide and with an 8 on 6-1/2 bolt pattern. The likely capacity of such a wheel is 3,750 pounds but could be 3,960 pounds or even 4,100 pounds depending on the manufacturer. But the safe bet is to go by the 3,750 pound capacity such as wheel # AM20750.

Answer 1

The Dexstar Steel Mini Mod Trailer Wheel, part #AM20761B has a zero offset. The wheel has a 110 psi rating and a capacity of 3750-lbs.

view full answer...

Answer 2

Karrier and Loadstar are two different brand names used by Kenda. There's no difference in quality or function between the two brand names. For a ST175/80-13 Radial trailer tire in load range D, I'd recommend part #AM10210 if you're…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 6

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 7

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 8

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 11

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 12

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6 inch whereas the 225/75-15 fits widths that are 5 inch to 6-1/2 inch. The 205 is 27.1 inches tall and the 225 is 28.4…

view full answer...

What is the Capacity of a 16" x 6" Trailer Wheel with 8 on 6-1/2 Bolt Pattern

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching