Complete Flat-Towing Setup for a 2009 Honda CR-V

Question

Question:

Would like to get a quote on a Blue Ox system for a 2009 Honda CRV tow bebind a Tiffin motorhome including tow bar, braking system and signal lights

asked by: Murray

0

Expert Reply:

In order to flat-tow your 2009 Honda CR-V with four wheels downs, which is the recommended way to tow this vehicle according to the owner's manual, you will need base plates, a tow bar, safety cables, a supplemental brake system, a flat-tow wiring harness, and a possible high-low adapter. I have attached my recommendations on the above items for you below.

Base Plates: Blue Ox Base Plate Kit part # BX2246 (See Install Video)

Tow Bar: Blue Ox Alpha Tow Bar part # BX7380 (See Install Video)

Supplemental Braking System: Blue Ox Patriot # BLU37TR

Flat-Tow Wiring Harness: Heavy Duty Magnetic Tow Lights part # TL21RK

High-Low Adapter: (See Article/Selection)

In addition to the above key components you will also need the Roadmaster Fuse Bypass part # RM76511 and the Roadmaster 12 Volt Outlet Kit part # RM-9332. The fuse bypass will be needed for the #34 fuse in the fuse box as this will prevent battery drain and the outlet kit is to power the braking system.

expert reply by: Conner L

0

Monique

12/18/2024

Is the 2009 Honda CRV EX AWD ok to flat tow behind motor home even if it is AWD? We want to make sure it won’t damage the transmission etc. Thanks

Jesse M.

12/18/2024

@Monique Looking at the online manual for the 2009 CRV they confirm that the vehicle is flat towable and they do not call out the AWD being an exclusion which means all models would be flat towable. All they say is never go over 65 mph and make sure you follow all of the procedures listed in your owners manual.

Answer 1

When installed on your vehicle, the RhinoRack #RRRVP15 will used the fixed points or holes existing in your roof as attachment points. This will place the bars 27-1/2 inches apart, measured from the center of the width of the front bar to the center…

view full answer...

Answer 2

Hello Paul, thanks for reaching out. The Blue Ox Acclaim Non-Binding Tow Bar #BX4330 can absolutely be used on your 2011 Honda CR-V. The CR-V has a curb weight of about 3,500 lbs so a 5K rated tow bar will be more than sufficient. Here are the rest…

view full answer...

Answer 3

For your 2008 Honda CR-V, you will want to start with the Blue Ox Base Plate Kit - Removable Arms #BX2246 which will be directly compatible with your tow bar. The tow bar you are describing is likely the old alpha or avail model, either of which will…

view full answer...

Answer 4

Yes a Curt base plate kit #C26KR will connect directly to the Blue Ox tow bar part #BX7380 that you referenced. For lighting you can use the diode kit, #RM-15267, and not have to worry about cutting into the taillight housing. This will splice into…

view full answer...

Answer 5

When installing the Blue Ox Base Plate Kit #BX2258 on the 2014 Honda CR-V we were able to remove the entire grille/front fascia assembly by simply taking off the various screws and rivets that are installed along the panel. We did not need to pinch…

view full answer...

Answer 6

If the 7-way on your motorhome is a factory 7-way then the fuse will be in the fuse box and the legend on the box or in your owner's manual should tell you which cavity the 12 volt power will be. If it's an aftermarket 7-way it's possible…

view full answer...

Answer 7

Hey Oscar, yes you can use a Curt tow bar like the Rambler part #C25DQ with a Blue Ox base plate kit like the part #BX3620 that you referenced. Do you have a Curt tow bar already? What are you flat towing?

view full answer...

Answer 8

The only parts you need to purchase to use your father's Falcon 2 Tow bar to flat tow your 2016 Jeep Wrangler 75th Anniversary is a baseplate, magnetic lights and and possibly a braking system and high low adapter. I recommend Roadmaster Base…

view full answer...

Answer 9

According to the owners manual for your 2015 Toyota Camry it can be pulled by a Tow Dolly #DM9713093 with the front wheels off the ground in an emergency situation. The only specification was to release the parking brake so your transmission can be…

view full answer...

Answer 10

Yes, I will be happy to tell you what you will need to flat tow your 2007 Honda CR-V behind your motorhome. There are 5 major components needed: base plates, tow bar, safety cables, lighting, and supplemental braking. For base plates I recommend…

view full answer...

Complete Flat-Towing Setup for a 2009 Honda CR-V

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching