Where Does Brake Controller Harness Install on 2015 Dodge Durango

Question

Question:

I purchased a trailer wiring harness with the Tekonsha p3 brake controller for 2015 Dodge Durango. The instructions are lacking. I hooked everything up as stated. There is nothing stating where I hook up the heavy gauge blue wire that is bundled up with the heavy gauge red and black wire that go to the front of the vehicle . The smaller blue wire is hooked to the white wire with the yellow stripe up in the head liner but the other one is in limbo.

asked by: Jim S

0

Expert Reply:

To install a p3 brake controller part # 90195 in a 2015 Dodge Durango you'd need to use the part # TK93VR which plugs into the port under the dash of your vehicle without requiring additional wiring.

If you check out the install video I attached at the 5:00 mark you can see where the harness is found. If you are trying to hardwire the controller wiring to the factory wiring we don't have a wiring guide to use.

expert reply by: Jameson C

0

Answer 1

That is a bit confusing as to why Dodge would have the plug installed on your 2015 Durango for the Adapter #TK93VR if your model didn't come with the tow package. Since it didn't come with the tow package you need to hardwire everything.…

view full answer...

Answer 2

When towing with your 2015 Dodge Durango RT and trailering a weight of 3500 or more, I recommend a electric proportional brake controller. With a proportional brake controller, you can get heavy-duty emergency braking, general braking or…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

To install a Redarc Tow Pro Liberty in your 2023 Toyota Tacoma Sport you will need the following parts: Redarc Tow-Pro Liberty Brake Controller item #RED24FR Plug-and-Play Wiring Harness for Redarc Tow-Pro Trailer Brake Controllers item #RED99FR…

view full answer...

Answer 6

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 7

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 8

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

Answer 9

The Redarc Tow-Pro Liberty #RED24FR is the way to go over the Elite #RED44FR as you get the nicer functions of the Elite at a lower price. The Elite has the ability to be the more preferred proportional style of controller as well as a time-delayed…

view full answer...

Answer 10

Hey Jonathan, congrats on the new truck! The Universal Mounting Panel item #331-TPSI-001 is what you'll need to install the control knob of the Redarc Tow-Pro Liberty item #RED53CR in your 2026 Nissan Frontier SV. It measures 1-8/16" tall x…

view full answer...

Answer 11

Hey, Stephen! We got just what you need. Since you don't have a tow package, I'm not sure if you have a hitch on your 2025 Ford Ranger so I'll include one just in case. Draw-Tite Max-Frame Trailer Hitch Receiver Part #DT35PR Curt…

view full answer...

Answer 12

Hi Richard! The best brake controllers on the market for your 2023 Ford Explorer XLT are going to be from Redarc. They're super easy to use and set up, and they are very reliable. They are the ones to get. Since you said you will be towing a…

view full answer...

Where Does Brake Controller Harness Install on 2015 Dodge Durango

Featured Help Information

Miscellaneous Media

Continue Researching