Replacement for Dexter Grease Seal 010-019-00  

Is it a disc caliper like the part #K71-636-00 or is it a drum brake component? I believe you are looking for the #K71-636-00 but wanted to make sure.

You really could use either one of the 68" #Y01158 or 78" #Y01159 bars, but I have a feeling that the 78" bars are going to stick out a little bit too far, so I do recommend going with the 68" Yakima HD Bars…

I checked directly with Yakima, and the shortest crossbar size for the OverHaul HD ladder rack on a 2021 Ford F-150 is indeed the 68 inch bars, and they say the 60 inch bars will not fit as they are too short. So the correct fit for your…

We do have a bearing kit that includes the correct bearings and races for the Dexter 031-030-02 and 031-032-02 bearings, as well as the 010-036-00 grease seal. The correct kit is the following: - Bearing Kit #BK3-300

We can get you a replacement for your TDE LP75 disc brake actuator; that's a 7,500 lb actuator that accepts a 2" hitch ball, and the correct option will depend on if your trailer tongue is 3" wide x 4" tall or…

I spoke with my contact at Dexter regarding your model 3K7258 axle that you referenced in your question. He was unable to pull up any specific bearing information using this model number. If you can locate the axle serial number, which should be…

The correct bearings, races, and seals for your 2021 Grand Design Imagine XLS 17MKE is the Hub Bearing Kit for Lippert, Dexter, and Al-Ko Axles part #BK2-100.

I really wish there was a way to determine what bearings a trailer needed without actually pulling the wheel off and checking, but there isn't. The only two solution I have for you would be to remove the hubs and get the numbers that are stamped…

I do have a recommendation for you, however, Yakima does not make an adapter for the Yakima HullHound Kayak Saddles w/ Tie-Downs part Y04079 that will allow them to work with the Thule Xsporter Pro Adjustable Height Truck Bed Ladder Rack part…

If your Tekonsha P3 Brake Controller, part #90195, displays the error message OUTPUT SHORTED NO BRAKES, the potential causes are a short in the brake output circuit somewhere between the brake controller and the trailer brake assemblies, or a shorted…

It does sound like there is a possible short with the brake magnets on your trailer, especially if all the wiring looks good between the brake controller and vehicle connector. I recommend first making sure that each magnet has one wire secured to…

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…