7-Way Diagram for 7-Way of 2014 Mercedes Sprinter 3500

Question

Question:

Socket is PA66-MD40 I need a pin map for the wires by function ie RT, LT, +, -, etc photos MB OEM female socket Thanks

asked by: Tom S

0

Expert Reply:

The PA66-MD40 is a standard 7-way which we have diagrams for. I attached a picture that shows how a standard RV 7-way gets wired up for you to check out.

expert reply by: Jameson C

0

click to enlarge

Answer 1

The Curt Trailer Hitch Receiver - Custom Fit - Class III - 2" #13358 installation instructions which I've attached state to torque all M12 fasteners to 79 lb-ft. If you don't have a torque wrench, I recommend the Powerbuilt #ALL944001…

view full answer...

Answer 2

On the trailer's 5-way connector the yellow wire with brown stripe is most likely a running light circuit but you want to be sure. There is sometimes a yellow/brown wire which is ran down the left side of the trailer for tail lights and a…

view full answer...

Answer 3

Your Demco Kar Kaddy SS Tow Dolly with Disc Brakes #DM9713045 with one light not working has some basic troubleshooting we can do. The light is not incandescent but rather LED so there isn't a bulb to check. You will want to check the wiring…

view full answer...

Answer 4

I checked with Redarc and a few other brake controller manufacturers and they state that your 2024 Mercedes Sprinter 3500XD does not have an OEM brake controller install port under the dash like previous models so you would have to hardwire in the…

view full answer...

Answer 5

In order to charge a towed vehicle while in tow you will need a charge line kit for both the vehicle and motorhome. For this, we have the Roadmaster Battery Charge Line Kit for Motorhomes part #RM-156-75 and Roadmaster Battery Charge Line Kit for…

view full answer...

Answer 6

If the 7-way you are referring to is the trailer side connector you will only need the blue wire in the 7-way if your trailer has electric trailer brakes. I do know that there are several trailers on the road with 7-way connectors for the charge line…

view full answer...

Answer 7

As long as your 2019 Mercedes-Benz Sprinter 2500 has a factory plugin connection point for the adapter part #3063-P you will not need to make any modifications to the adapter, it will plug right in into the factory plug and the other end to a…

view full answer...

Answer 8

If you have no power on the brake controller output terminal of your 7-way (which is the 5 o'clock pin) then you most likely have a short in your wire or a bad brake controller. I recommend starting your troubleshooting using a circuit tester…

view full answer...

Answer 9

If you are looking for a way to power the trailer brakes you would not run the blue wire of the 7-way to the positive post of your battery. Instead you would run that wire up to the blue wire of a brake controller like the part #90885 that you…

view full answer...

Answer 10

Under the seat of your 2012 Mercedes Sprinter there should be a harness with a green connector. That will be the brake controller harness. We don't have an adapter that plugs right in but you can cut the connector off and hardwire directly to the…

view full answer...

Answer 11

Since your 2012 Mercedes Sprinter does not have the wiring to plug in a brake controller but does have a 7-Way trailer connector you will need to do a little hardwiring to install a controller such as #90195. You will need installation kit #5506.…

view full answer...

Answer 12

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

7-Way Diagram for 7-Way of 2014 Mercedes Sprinter 3500

Continue Researching