Wiring a Stop/Turn/Tail Light to Molded 7-Way Connector
Updated 10/31/2017 | Published 10/30/2017
Products Featured in This Question
Question:
How to wire a 7 way molded trailer wire connector H20044 to two stop/turn/tail trailer lights ST21RS ST20RS with two wires protruding. Have 4 wire flex cable for connecting wire.
asked by: Mike K
Helpful Expert Reply:
The Stop/Turn/Tail Trailer Lights # ST21RS and # ST20RS will ground through the mounting hardware, so the two wires will need to connect to the Hopkins 7-Way Molded Trailer Wire Connector # H20044 simply by function. The red wire on the lights is for the tail light function, which is the green wire on the molded connector. The black wire on the lights is for the turn signal and brake functions, which are the red (driver's side) and brown (passenger's side) wires on the molded connector.
Product Page this Question was Asked From
7-Way Molded Trailer Wire Connector, 6' Long
- Trailer Wiring
- Trailer Connectors
- Trailer End Connector
- 7 Blade
- Plug and Lead
- Hopkins
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Q&A: Can I Add Electric Brakes To A 1993 EZ Loader Boat Trailer
- Article: Holiday 2025 | Best Gifts for RVing
- Article: Holiday 2025 | Best Gifts for Towers
- Q&A: Is there a Weigh Safe 180 Hitch 2 Ball Mount w/a Tongue Weight Scale?
- Q&A: Wheel Stud Replacement Recommendation for Dexter Hub 8-285
- Q&A: Closest Metric Replacement Tire Size for 7.00-15 Tire on Livestock Trailer
- Q&A: Instructions to Wire a Trailer for Electric Brakes
- Q&A: What Gauge Wire Should be Used to Wire Trailer Brakes
- Q&A: What Does Yellow Wire of 7-Way Molded Trailer Wire Connector H20044 Wire To
- Article: Brake Controller Installation: Starting from Scratch