What is Total Weight of Aluminum A-Frame Trailer Tongue Toolbox # 350975

Question

Question:

What is the weight of this box?

asked by: Scott

0

Expert Reply:

The total weight of the Aluminum A-Frame Trailer Tongue Toolbox # 350975 is 35 lbs.

expert reply by: Jameson C

0

Answer 1

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 2

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 3

Hey Joe, welcome back! I'm not entirely sure where our 15" measurement came from but you will be able to add your 13" diameter tank to the inside of the #3371701385. The front to back measurement is 16.16" and then the lip will…

view full answer...

Answer 4

Hey Doug, welcome back! Not sure what size you 6 volt batteries are but lets say they're something along the lines of the AGM Deep Cycle 6V27, which measures 12.05" L x 6.61" W x 8.98" H. The Buyers Products Trailer Tongue Toolbox…

view full answer...

Answer 5

From what I can find the Norcold N306.3 fridge has a 2.7 cu ft capacity and is 20-1/8" wide and 26" tall. The most similar option we can offer is the 3.2 cu ft Everchill RV Mini Refrigerator #324-000111. The #324-000111 measures…

view full answer...

Answer 6

The best way to jack up a boat trailer with torsion axles, or straight axles for that matter, is to use a trailer jack that is rated high enough for the weight of the trailer at the point the jack is installed. Going with a higher capacity than…

view full answer...

Answer 7

Hey Jeff, thanks for reaching out. I went out to our warehouse and measured the Demco Spare Tire Mount #DM15851-76. From the upright post to the wheel mounting surface I measured 4-3/16". I edited a picture to help illustrate. Hope this helps!

view full answer...

Answer 8

Hey Robin, the Dometic AC unit you have is a Brisk unit so for a cover the part #290-3027 would be what you would need. If you needed a shroud the part #DMC46FR is correct fit.

view full answer...

Answer 9

Surprisingly enough, we don't offer a cap that would slip over the 7-way connector on your trailer and protect the contacts from the elements. A light coat of dielectric grease, part #11755 would act to exclude moisture form the connector. To…

view full answer...

Answer 10

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 11

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

What is Total Weight of Aluminum A-Frame Trailer Tongue Toolbox # 350975

Product Page this Question was Asked From

Continue Researching