Replacement Parts for Shelby 5854A Trailer Jack

Question

Question:

I have a shelby 5854a trailer jack, but I need the nut on the screw. Are those still available or something that will work?

asked by: Rob

0

Expert Reply:

I do have a solution for you, however replacement parts for your Shelby 5854A Trailer Jack are no longer available.

I recommend simply replacing your Shelby jack with a similar unit like the Fulton Bolt-Thru Swivel Trailer Jack # FXPD15L. This zinc plated marine jack has a lift capacity of 1,500 pounds and a total lift of 12 inches. It is a bolt-on installation and the hardware is included.

I have attached a short video demonstration on this product so you can get a better look at its features.

expert reply by: Chris R

0

Answer 1

Shelby has been out of business for a number of years now and so there unfortunately are no replacement parts readily available. You might be able to find something where old parts are regularly sold, but you'll probably have to do a lot of…

view full answer...

Answer 2

If you are looking for a replacement cap that fits a 2 inch outer diameter tube you would want #LC115863 or #PS500322. These fit an inner diameter of 1-3/4 inches and should fit your Shelby jack. You will want to measure to confirm fit, but this is…

view full answer...

Answer 3

To replace your Shelby 5856A jack I recommend the Fulton Round Snap-Ring Swivel Marine Jack #FTJ120W0301. We have had customers say that this fits the mounting plate for the Shelby 5784A perfectly so ti's going to be the easiest install possible.…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 8

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 9

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 10

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Replacement Parts for Shelby 5854A Trailer Jack

Featured Help Information

Miscellaneous Media

Continue Researching