Replacement Plastic Cap for Shelby Swivel Jack

Question

Question:

I have a Shelby swivel jack and Im looking for a replacement plastic black cap that covers the end cap. Would you have any replacement parts? Thx

asked by: Breck D

1

Helpful Expert Reply:

If you are looking for a replacement cap that fits a 2 inch outer diameter tube you would want # LC115863 or # PS500322. These fit an inner diameter of 1-3/4 inches and should fit your Shelby jack. You will want to measure to confirm fit, but this is the standard size.

expert reply by: Jason S

1

click to enlarge

Answer 1

If you are looking for a replacement cap that fits a 2 inch inner diameter tube you would want the part #LC115863.

view full answer...

Answer 2

The 2 Inch Replacement Cap #LC115863 is the cap you want for a round jack with 1-3/4" inside diameter jack tube.

view full answer...

Answer 3

Replacement Top Cap for Dutton-Lainson Jacks Item #DL6602 fits jacks with an outer tube diameter of 2.5 inches and inner tube diameter of 2 inches. I went out and took some measurements for you (see photo). The ridges on the inside of the Replacement…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 8

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 9

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 10

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 11

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 12

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Replacement Plastic Cap for Shelby Swivel Jack

Products Featured in This Question

Continue Researching