Replacement Trailer Clearance Light for Grote 9015

Question

Question:

Id like to replace Grote 9015 red and amber rectangular clearance lights ~1inch x 3 with LED. Need 2-hole mounting on ~ 1.75inch centers. Do you have anything close?

asked by: Eric

0

Expert Reply:

After I did some research, it looks like Grote 9015 corresponds to # MC68AB and the replacement lens for it is # A68AB.

The light itself including the housing measures 3-1/2 inches side to side, 1-1/8 inches top to bottom and sticks out 1 inch. Compare these measurements to the lights you have to determine if this is the correct fit.

expert reply by: Jameson C

0

click to enlarge

Answer 1

Hello Dan. Yes, it does. You would also need an air distribution box, controller and thermostat to operate the GE Appliances Deluxe Plus RV AC #GE74FR. The distribution box, controller and thermostat are available as part #GE56FR which is for a…

view full answer...

Answer 2

Hey Faye, after I did some research, it looks like Grote 9015 corresponds to #MC68AB and the replacement lens for it is #A68AB.

view full answer...

Answer 3

The Optronics Clearance or Side Marker Trailer Light #MC68AB and #MC68AB are the same size as the Grote 9015 lights. Unfortunately they are not available from the manufacturer with a LED light. You can change the incandescent bulb to an LED Bulb…

view full answer...

Answer 4

We do have the white Replacement Exterior Half-Moon Trailer Vent for 3" Diameter Hole #WHMAV2 which is the white version of the #HMAV2 that you referenced and also is what you sent in a picture of so it would work well for you.

view full answer...

Answer 5

What some customers have done is used an electric winch such as #DL25200 to raise and lower heavy ramp doors. The winch would have to be mounted up high and back a few feet from the door opening. The line will need to come straight out of the winch…

view full answer...

Answer 6

I called my contacts at our winch suppliers to see if there were any winches available that perform as you requested. I was unable to find a winch that had an auto shutoff when the winch senses a trailer door is closed since winches constantly feel…

view full answer...

Answer 7

The ramp doors will use a spring system like #CB250D96SHD. Then you can use a winch like Bulldog Winch Trailer Winch - Wire Rope - Hawse Fairlead - 3,400 lbs #BDW15017 to help raise and lower the door.

view full answer...

Answer 8

With an Enclosed Trailer Ramp Spring #ERS120D81 when the door is lowered it will pull the cables which will turn the pulleys and put tension on the springs. The cables could not be detached with the ramp door lowered because the springs would…

view full answer...

Answer 9

You wouldn't use a spring like #RS16933LH because it produces 2,000 foot pounds of torque and you would not be able to open the ramp. What I recommend is either the Rack'em Double Barrel tailgate assist, #RA-27C. The Double Barrel will reduce…

view full answer...

Answer 10

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 11

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 12

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Replacement Trailer Clearance Light for Grote 9015

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching