Recommended Kodiak 225 Caliper Rebuild Kit With Dust Boot
Updated 07/12/2017 | Published 07/11/2017
Products Featured in This Question
Question:
Hi there, I am in the process of rebuilding my Kodiak 225 Calipers. I am struggling to remove the old dust seals...they seem to be adhered to the caliper...maybe melted on? Is there a trick to removing them?
asked by: John
Expert Reply:
There is not any melting that is done to keep the dust seals on, but they may have used an adhesive of some sort. Normally they are just a tight fit and a small flat head screwdriver can be used with a rubber mallet to remove it.
Most of the time you have to replace the seals because of wear anyway, so I recommend using the Kodiak Disc Brake Caliper Rebuild Kit for 3,500 lb to 6,000 lb Trailer Brakes # KDBC225KIT or # KDBC250KIT if you have the 7 or 8K axles and brakes.
Product Page this Question was Asked From
Kodiak Disc Brake Caliper Rebuild Kit for 3,500 lb to 6,000 lb Trailer Brakes
- Accessories and Parts
- Trailer Brakes
- Disc Brakes
- 3500 lbs
- 6000 lbs
- Caliper Parts
- Rebuild Kit
- Kodiak
more information >
Continue Researching
- Search Results: trailer hubs
- Search Results: trailer hubs and drums
- Search Results: brake hoses
- Search Results: kodiak
- Search Results: kodiak 225
- Search Results: 225
- Shop: Kodiak Disc Brakes - 8" Hub/Rotor - 5 on 4-1/2 - Dacromet - 2,000 lbs - E-Z Lube
- Search Results: kodiak brake lines
- Article: Trailer Wiring Diagrams
- Shop: Kodiak Disc Brake Caliper Rebuild Kit for 3,500 lb to 6,000 lb Trailer Brakes
- Shop: Kodiak 10" Hub-and-Rotor Assembly - 5 on 4-1/2 - Dacromet - 3,500 lbs
- Shop: Titan Disc Brake Kit and Leverlock Actuator w/ Electric Lockout - Tandem, 3,500-lb Axle
- Shop: Terran Axle Trailer Idler Hub Assembly for 5,200 to 6,000 lbs Axle - 6 on 5-1/2
- Video: Review of Caliber Boat Trailer Parts - Rollers - CA25AJ
- Article: How to Bleed Your Trailer Surge Brakes
- Video: Review of Kodiak Disc Brake Caliper Rebuild Kit - KDBC225KIT
- Shop: Bearing Kit, 15123/ 25580 Bearings, 10-36 Seal
- Shop: Demco Hydraulic Brake Line Kit for Tandem Torsion-Axle Trailers - Drum or Disc Brakes
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Video: The Low-Down on the Kodiak Disc Brake Kit
- Video: All You Need to Know About the Kodiak Disc Brakes
- Video: What to Know About the Kodiak Disc Brake Kit
- Video: Breaking Down the Kodiak Trailer Hub for 3,500-lb Axles
- Video: Hands-On with the Kodiak Trailer Hub for 3,500-lb Axles
- Q&A: Will The DeeMaxx Dust Boot Also Fit 3,500LB Kodiak Disc Brake Calipers?
- Q&A: Do You Need To Replace The Calipers With A Dust Boot Cover That Is Cracking?
- Q&A: Dimensions of the Replacement Silicone Dust Boot w/ Stainless Steel Core Part # K225BSSI
- Shop: Brake Controller
- Q&A: Troubleshooting An Ausco EOH Actuator That Takes 5 Seconds To Start Pumping Fluid
- Q&A: How to Wire the Dexter Electric Over Hydraulic Trailer Brake Actuator
on Accessories and Parts
