Will Trailer Hub and Drum Assembly # AKHD-545-35-K Work On EZ Loader Trailer

Updated 06/07/2017 | Published 06/05/2017

Products Featured in This Question

Trailer Hub and Drum Assembly - 3,500-lb Axles - 10" Diameter - 5 on 4-1/2 - Pre-Greased

(1259)

$91.21

Grease Seal - Double Lip - ID 1.719" / OD 2.565" - for 3,500-lb Axles

(2707)

$8.07

Replacement Race for L44643 and L44649 Bearings

(1272)

$4.88

Replacement Trailer Hub Bearing - L44649

(2117)

$21.55

Replacement Race for L68149 Bearing

(1272)

$4.20

Replacement Trailer Hub Bearing - L68149

(2117)

$17.10

4" Carbon Fiber Digital Caliper

(26)

$11.55

Question:

Hi - I have an EZ Loader with 10inch hydraulic drum brakes. I can find no make on the axle so it must just be an EZ Loader part. Would these drums work? My drums appear to be 5 on 4 1/2 as well.

asked by: Ron

Expert Reply:

The bolt pattern of the # AKHD-545-35-K is a 5 on 4-1/2, but you will need to know what size your spindle is on your trailer to make sure the drums will work.

The easiest way to see what you need is to pull the hub and drum and get the numbers off of the bearings. It will be stamped or etched on the side of the bearing as shown in the attached photo. If you cannot find the numbers you will need to use a digital caliper like part # PTW80157 and measure the spindle where the bearings ride and also the inside diameter of the hub.

The # AKHD-545-35-K comes with the bearings, races, grease seal, grease cap, and lug nuts included. The inner bearing is # L68149 and the outer is # L44649 . The inner race is # L68111 and the outer is # L44610. The grease seal is # 58846.